The Uniquiti AC Pro and Ubiquiti AC Mesh Pro currently have the "Primary" and "Secondary" ethernet ports configured to offer LAN as well as WAN. However, Uiquiti describes the following behavior for the devices Ethernet ports:
> Secondary UniFi Access Point (UAP) Ethernet ports don't > provide PoE passthrough (to run current to a second powered > device), but they do support data passthrough. > It serves as a bridged interface between main / secondary > Ethernet port. To reduce confusion for users (as LAN and WAN functionality is not visible on the device itself), configure both ports to offer LAN functionality. Users can still configure a WAN interface on a port they are able to choose. CC: Lucian Cristian <[email protected]> Reported-by: Florian Klink <[email protected]> Signed-off-by: David Bauer <[email protected]> --- .../linux/ath79/generic/base-files/etc/board.d/02_network | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index dbb722482b..610e3e3ce8 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -183,8 +183,6 @@ ath79_setup_interfaces() ;; nec,wg1200cr|\ ubnt,nanostation-ac|\ - ubnt,unifiac-mesh-pro|\ - ubnt,unifiac-pro|\ yuncore,a782|\ yuncore,xd4200) ucidef_add_switch "switch0" \ @@ -305,6 +303,11 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth0" "5:lan" "1:wan" ;; + ubnt,unifiac-mesh-pro|\ + ubnt,unifiac-pro) + ucidef_add_switch "switch0" \ + "0@eth0" "2:lan:1" "3:lan:2" + ;; zbtlink,zbt-wd323|\ xiaomi,mi-router-4q) ucidef_set_interface_wan "eth1" -- 2.25.1 _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
