Hi all,
Hi all, I am trying to run openwrt on rk3328, but the kernel
hanged when booting, below is the log.
Any hints will be appreciated.
U-Boot 2020.01 (Apr 07 2020 - 11:55:14 +0000) Model: Radxa Rockpi E DRAM: 1022
MiB PMIC: RK8050 (on=0x40, off=0x00) MMC: rksdmmc@ff500000: 1,
rksdmmc@ff520000: 0 Loading Environment from MMC... *** Warning - bad CRC,
using default environment In: serial@ff130000 Out: serial@ff130000 Err:
serial@ff130000 Model: Radxa Rockpi E Net: eth0: ethernet@ff540000 Hit any
key to stop autoboot: 0 Card did not respond to voltage select! switch to
partitions #0, OK mmc1 is current device Scanning mmc 1:1... Found
/extlinux/extlinux.conf Retrieving file: /extlinux/extlinux.conf 205 bytes read
in 7 ms (28.3 KiB/s) 1: kernel-5.4 Retrieving file: /Image 7485448 bytes
read in 330 ms (21.6 MiB/s) append: earlycon=uart8250,mmio32,0xff130000
console=ttyS2,1500000n8 rw root=PARTUUID=b921b045-1d rootwait rootfstype=ext4
init=/sbin/init Retrieving file: /rk3328-rockpi-e.dtb 33554 bytes read in 8 ms
(4 MiB/s) ## Flattened Device Tree blob at 01f00000 Booting using the fdt
blob at 0x1f00000 Loading Device Tree to 000000003df1d000, end
000000003df28311 ... OK Starting kernel ... [ 0.000000] Booting Linux on
physical CPU 0x0000000000 [0x410fd034] [ 0.000000] Linux version 5.4.28
(rockpi@rockpi-dev) (gcc version 8.4.0 (OpenWrt GCC 8.4.0 r12776-437eb41f23))
#0 SMP Tue Apr 7 11:55:14 2020 [ 0.000000] Machine model: Radxa ROCK Pi E [
0.000000] earlycon: uart8250 at MMIO32 0x00000000ff130000 (options '') [
0.000000] printk: bootconsole [uart8250] enabled [ 0.000000] psci: probing
for conduit method from DT. [ 0.000000] psci: PSCIv1.0 detected in firmware.
[ 0.000000] psci: Using standard PSCI v0.2 function IDs [ 0.000000] psci:
MIGRATE_INFO_TYPE not supported. [ 0.000000] psci: SMC Calling Convention
v1.0 [ 0.000000] percpu: Embedded 19 pages/cpu s38424 r8192 d31208 u77824 [
0.000000] Detected VIPT I-cache on CPU0 [ 0.000000] Built 1 zonelists,
mobility grouping on. Total pages: 257544 [ 0.000000] Kernel command line:
earlycon=uart8250,mmio32,0xff130000 console=ttyS2,1500000n8 rw
root=PARTUUID=b921b045-1d rootwait rootfstype=ext4 init=/sbin/init [
0.000000] Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes,
linear) [ 0.000000] Inode-cache hash table entries: 65536 (order: 7, 524288
bytes, linear) [ 0.000000] mem auto-init: stack:off, heap alloc:off, heap
free:off [ 0.000000] Memory: 1018444K/1046528K available (5054K kernel code,
334K rwdata, 1244K rodata, 640K init, 281K bss, 28084K reserved, 0K
cma-reserved) [ 0.000000] SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=4,
Nodes=1 [ 0.000000] rcu: Hierarchical RCU implementation. [ 0.000000]
rcu: CONFIG_RCU_FANOUT set to non-default value of 32. [ 0.000000] rcu:
RCU restricting CPUs from NR_CPUS=256 to nr_cpu_ids=4. [ 0.000000] rcu:
RCU calculated value of scheduler-enlistment delay is 25 jiffies. [
0.000000] rcu: Adjusting geometry for rcu_fanout_leaf=16, nr_cpu_ids=4 [
0.000000] NR_IRQS: 64, nr_irqs: 64, preallocated irqs: 0 [ 0.000000] GIC:
Using split EOI/Deactivate mode [ 0.000000] random: get_random_bytes called
from start_kernel+0x2dc/0x450 with crng_init=0 [ 0.000000] arch_timer: cp15
timer(s) running at 24.00MHz (phys). [ 0.000000] clocksource:
arch_sys_counter: mask: 0xffffffffffffff max_cycles: 0x588fe9dc0, max_idle_ns:
440795202592 ns [ 0.000007] sched_clock: 56 bits at 24MHz, resolution 41ns,
wraps every 4398046511097ns [ 0.001345] Calibrating delay loop (skipped),
value calculated using timer frequency.. 48.00 BogoMIPS (lpj=96000) [
0.002323] pid_max: default: 32768 minimum: 301 [ 0.002957] Mount-cache hash
table entries: 2048 (order: 2, 16384 bytes, linear) [ 0.003632]
Mountpoint-cache hash table entries: 2048 (order: 2, 16384 bytes, linear) [
0.006152] ASID allocator initialised with 32768 entries [ 0.006805] rcu:
Hierarchical SRCU implementation. [ 0.008023] smp: Bringing up secondary
CPUs ... [ 0.009010] Detected VIPT I-cache on CPU1 [ 0.009084] CPU1:
Booted secondary processor 0x0000000001 [0x410fd034] [ 0.009735] Detected
VIPT I-cache on CPU2 [ 0.009789] CPU2: Booted secondary processor
0x0000000002 [0x410fd034] [ 0.010386] Detected VIPT I-cache on CPU3 [
0.010435] CPU3: Booted secondary processor 0x0000000003 [0x410fd034] [
0.010530] smp: Brought up 1 node, 4 CPUs [ 0.013785] SMP: Total of 4
processors activated. [ 0.014213] CPU features: detected: 32-bit EL0 Support
[ 0.014680] CPU features: detected: CRC32 instructions [ 0.015226] CPU
features: emulated: Privileged Access Never (PAN) using TTBR0_EL1 switching [
0.015980] CPU: All CPU(s) started at EL2 [ 0.016372] alternatives: patching
kernel code [ 0.027185] clocksource: jiffies: mask: 0xffffffff max_cycles:
0xffffffff, max_idle_ns: 7645041785100000 ns [ 0.028128] futex hash table
entries: 1024 (order: 4, 65536 bytes, linear) [ 0.028981] pinctrl core:
initialized pinctrl subsystem [ 0.029940] NET: Registered protocol family 16
[ 0.030855] DMA: preallocated 256 KiB pool for atomic allocations [
0.057761] clocksource: Switched to clocksource arch_sys_counter [ 0.059496]
NET: Registered protocol family 2 [ 0.060488] tcp_listen_portaddr_hash hash
table entries: 512 (order: 1, 8192 bytes, linear) [ 0.061344] TCP
established hash table entries: 8192 (order: 4, 65536 bytes, linear) [
0.062174] TCP bind hash table entries: 8192 (order: 5, 131072 bytes, linear) [
0.063013] TCP: Hash tables configured (established 8192 bind 8192) [
0.063764] UDP hash table entries: 512 (order: 2, 16384 bytes, linear) [
0.064403] UDP-Lite hash table entries: 512 (order: 2, 16384 bytes, linear) [
0.065286] NET: Registered protocol family 1 [ 0.067377] workingset:
timestamp_bits=46 max_order=18 bucket_order=0 [ 0.074878] squashfs: version
4.0 (2009/01/31) Phillip Lougher [ 0.075589] jffs2: version 2.2 (NAND)
(SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [
0.078456] Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled [
0.080981] sdhci: Secure Digital Host Controller Interface driver [ 0.081556]
sdhci: Copyright(c) Pierre Ossman [ 0.082014] Synopsys Designware Multimedia
Card Interface Driver [ 0.083364] dwmmc_rockchip ff500000.dwmmc: IDMAC
supports 32-bit address mode. [ 0.084043] dwmmc_rockchip ff500000.dwmmc:
Using internal DMA controller. [ 0.084667] dwmmc_rockchip ff500000.dwmmc:
Version ID is 270a [ 0.085256] dwmmc_rockchip ff500000.dwmmc: DW MMC
controller at irq 24,32 bit host data width,256 deep fifo [ 0.097901]
mmc_host mmc0: Bus speed (slot 0) = 400000Hz (slot req 400000Hz, actual
400000HZ div = 0) [ 0.110764] dwmmc_rockchip ff520000.dwmmc: IDMAC supports
32-bit address mode. [ 0.111450] dwmmc_rockchip ff520000.dwmmc: Using
internal DMA controller. [ 0.112100] dwmmc_rockchip ff520000.dwmmc: Version
ID is 270a [ 0.112696] dwmmc_rockchip ff520000.dwmmc: DW MMC controller at
irq 25,32 bit host data width,256 deep fifo [ 0.113667] mmc_host mmc1: card
is non-removable. [ 0.125850] mmc_host mmc1: Bus speed (slot 0) = 400000Hz
(slot req 400000Hz, actual 400000HZ div = 0) [ 0.137979] sdhci-pltfm: SDHCI
platform and OF driver helper [ 0.139566] NET: Registered protocol family 10
[ 0.141313] Segment Routing with IPv6 [ 0.141838] NET: Registered
protocol family 17 [ 0.142310] 8021q: 802.1Q VLAN Support v1.8
content of the config file is:
label kernel-5.4 kernel /Image fdt /rk3328-rockpi-e.dtb append
earlycon=uart8250,mmio32,0xff130000 console=ttyS2,1500000n8 rw
root=PARTUUID=b921b045-1d rootwait rootfstype=ext4 init=/sbin/init
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
