Hi, > -----Original Message----- > From: openwrt-devel [mailto:[email protected]] > On Behalf Of [email protected] > Sent: Freitag, 27. März 2020 04:33 > To: [email protected] > Cc: Pavel Balan <[email protected]> > Subject: [OpenWrt-Devel] [PATCH v6] ath79: add support for COMFAST CF- > E130N v2 > > From: Pavel Balan <[email protected]> > > This patch adds support for the COMFAST CF-E130N v2, an outdoor wireless > CPE with a single Ethernet port and a 802.11bgn radio. > > Specifications: > > - QCA9531 SoC > - 1x 10/100 Mbps Ethernet with PoE-in support > - 64 MB of RAM (DDR2) > - 16 MB of FLASH > - 5 dBi built-in antenna > - POWER/LAN/WLAN green LEDs > - 4x RSSI LEDs (2x red, 2x green) > - UART (115200 8N1) and GPIO (J9) headers on PCB > > Flashing instructions: > > The original firmware is based on OpenWrt so a sysupgrade image can be > installed via the stock web GUI. > > The U-boot bootloader also contains a backup TFTP client to upload the > firmware from. Upon boot, it checks its ethernet network for the IP > 192.168.1.10. Host a TFTP server and provide the image to be flashed as file > firmware_auto.bin. > > Signed-off-by: Pavel Balan <[email protected]> > --- > Run-tested on hardware. > > Changes since v5: > > Made partition@7e0000 read-only. > > Changed IMAGE_SIZE to 7936k.
it looks like you have actually sent the v5 version of your patch again, as the v6-changes you report are not included. Anyway, I've added these (and a few others) myself and pushed the result to my staging tree here: https://git.openwrt.org/?p=openwrt/staging/adrian.git;a=shortlog;h=refs/heads/staging Please run this on your device and check whether everything is okay, so I can merge this. Despite, I'd be interested whether the MAC address from calibration data (art 0x1002) is actually the same as art 0x0, so we can drop mtd-mac-address from wmac. Best Adrian > > --- > .../ath79/dts/qca9531_comfast_cf-e130n-v2.dts | 150 > ++++++++++++++++++ > .../generic/base-files/etc/board.d/01_leds | 8 + > .../generic/base-files/etc/board.d/02_network | 1 + > target/linux/ath79/image/generic.mk | 10 ++ > 4 files changed, 169 insertions(+) > create mode 100644 target/linux/ath79/dts/qca9531_comfast_cf-e130n- > v2.dts > > diff --git a/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts > b/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts > new file mode 100644 > index 0000000000..dc1e037307 > --- /dev/null > +++ b/target/linux/ath79/dts/qca9531_comfast_cf-e130n-v2.dts > @@ -0,0 +1,150 @@ > +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT /dts-v1/; > + > +#include <dt-bindings/gpio/gpio.h> > +#include <dt-bindings/input/input.h> > + > +#include "qca953x.dtsi" > + > +/ { > + compatible = "comfast,cf-e130n-v2", "qca,qca9531"; > + model = "COMFAST CF-E130N v2"; > + > + aliases { > + serial0 = &uart; > + led-boot = &led_rssihigh; > + led-failsafe = &led_rssihigh; > + led-upgrade = &led_rssihigh; > + label-mac-device = ð1; > + }; > + > + leds { > + compatible = "gpio-leds"; > + > + pinctrl-names = "default"; > + > + wlan { > + label = "cf-e130n-v2:green:wlan"; > + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; > + linux,default-trigger = "phy0tpt"; > + }; > + > + lan { > + label = "cf-e130n-v2:green:lan"; > + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; > + }; > + > + unused { > + label = "cf-e130n-v2:green:unused"; > + gpios = <&gpio 3 GPIO_ACTIVE_LOW>; > + }; > + > + rssilow { > + label = "cf-e130n-v2:red:rssilow"; > + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; > + }; > + > + rssimediumlow { > + label = "cf-e130n-v2:red:rssimediumlow"; > + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; > + }; > + > + rssimediumhigh { > + label = "cf-e130n-v2:green:rssimediumhigh"; > + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; > + }; > + > + led_rssihigh: rssihigh { > + label = "cf-e130n-v2:green:rssihigh"; > + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; > + }; > + }; > + > + keys { > + compatible = "gpio-keys"; > + > + reset { > + label = "reset"; > + linux,code = <KEY_RESTART>; > + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; > + debounce-interval = <60>; > + }; > + }; > +}; > + > +&spi { > + status = "okay"; > + > + num-cs = <1>; > + > + flash@0 { > + compatible = "jedec,spi-nor"; > + reg = <0>; > + spi-max-frequency = <25000000>; > + > + partitions { > + compatible = "fixed-partitions"; > + #address-cells = <1>; > + #size-cells = <1>; > + > + partition@0 { > + label = "u-boot"; > + reg = <0x000000 0x010000>; > + read-only; > + }; > + > + art: partition@10000 { > + label = "art"; > + reg = <0x010000 0x010000>; > + read-only; > + }; > + > + partition@20000 { > + compatible = "denx,uimage"; > + label = "firmware"; > + reg = <0x020000 0x7c0000>; > + }; > + > + partition@7e0000 { > + compatible = "denx,uimage"; > + label = "configs"; > + reg = <0x7e0000 0x010000>; > + }; > + > + partition@7f0000 { > + label = "nvram"; > + reg = <0x7f0000 0x010000>; > + read-only; > + }; > + }; > + }; > +}; > + > +&uart { > + status = "okay"; > + > +}; > + > +ð0 { > + compatible = "syscon", "simple-mfd"; > +}; > + > +ð1 { > + status = "okay"; > + > + phy-handle = <&swphy0>; > + > + mtd-mac-address = <&art 0x0>; > + > + gmac-config { > + device = <&gmac>; > + switch-phy-swap = <1>; > + }; > +}; > + > +&wmac { > + status = "okay"; > + > + mtd-mac-address = <&art 0x0>; > + mtd-cal-data = <&art 0x1000>; > +}; > diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds > b/target/linux/ath79/generic/base-files/etc/board.d/01_leds > index fbb0d0ea03..3046d34605 100755 > --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds > +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds > @@ -47,6 +47,14 @@ comfast,cf-e120a-v3) > ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" > "$boardname:green:rssimediumhigh" "wlan0" "51" "100" > ucidef_set_led_rssi "rssihigh" "RSSIHIGH" > "$boardname:green:rssihigh" "wlan0" "76" "100" > ;; > +comfast,cf-e130n-v2) > + ucidef_set_led_netdev "lan" "LAN" "$boardname:green:lan" "eth0" > + ucidef_set_rssimon "wlan0" "200000" "1" > + ucidef_set_led_rssi "rssilow" "RSSILOW" "$boardname:red:rssilow" > "wlan0" "1" "100" > + ucidef_set_led_rssi "rssimediumlow" "RSSIMEDIUMLOW" > "$boardname:red:rssimediumlow" "wlan0" "26" "100" > + ucidef_set_led_rssi "rssimediumhigh" "RSSIMEDIUMHIGH" > "$boardname:green:rssimediumhigh" "wlan0" "51" "100" > + ucidef_set_led_rssi "rssihigh" "RSSIHIGH" > "$boardname:green:rssihigh" "wlan0" "76" "100" > + ;; > comfast,cf-e313ac) > ucidef_set_led_switch "lan" "LAN" "$boardname:green:lan" > "switch0" "0x02" > ucidef_set_led_netdev "wan" "WAN" "$boardname:green:wan" > "eth1" > diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network > b/target/linux/ath79/generic/base-files/etc/board.d/02_network > index 10ca213e70..b1ecc066fd 100755 > --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network > +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network > @@ -14,6 +14,7 @@ ath79_setup_interfaces() > alfa-network,ap121f|\ > aruba,ap-105|\ > avm,fritz300e|\ > + comfast,cf-e130n-v2|\ > devolo,dvl1200i|\ > devolo,dvl1750c|\ > devolo,dvl1750i|\ > diff --git a/target/linux/ath79/image/generic.mk > b/target/linux/ath79/image/generic.mk > index 70631c20d0..256481ece3 100644 > --- a/target/linux/ath79/image/generic.mk > +++ b/target/linux/ath79/image/generic.mk > @@ -258,6 +258,16 @@ define Device/comfast_cf-e120a-v3 endef > TARGET_DEVICES += comfast_cf-e120a-v3 > > +define Device/comfast_cf-e130n-v2 > + ATH_SOC := qca9531 > + DEVICE_VENDOR := COMFAST > + DEVICE_MODEL := CF-E130N > + DEVICE_VARIANT := v2 > + DEVICE_PACKAGES := rssileds kmod-leds-gpio -swconfig -uboot-envtools > + IMAGE_SIZE := 8000k > +endef > +TARGET_DEVICES += comfast_cf-e130n-v2 > + > define Device/comfast_cf-e313ac > ATH_SOC := qca9531 > DEVICE_VENDOR := COMFAST > -- > 2.17.1 > > > _______________________________________________ > openwrt-devel mailing list > [email protected] > https://lists.openwrt.org/mailman/listinfo/openwrt-devel
openpgp-digital-signature.asc
Description: PGP signature
_______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
