TP-Link has developed a number of access points based on the AP152 reference board. In the EAP-series of 802.11ac access points, this includes the following devices with one ethernet port: * EAP225 v1/v2 * EAP225 v3 * EAP225-Outdoor v1 * EAP245 v1
Since the only differences between these devices are the ath10k wireless radios and LEDs, a common base is provided for the overlapping support requirements. Hardware commonalities: * SoC: QCA9563-AL3A MIPS 74kc v5.0 @ 775MHz, AHB @ 258MHz * RAM: 128MiB DDR2 @ 650MHz * Flash: 16MiB SPI NOR * Wi-Fi 2.4GHz: provided by SoC * Wi-Fi 5Ghz: ath10k chip on PCIe * Ethernet: AR8033-AL1A, one 1GbE port (802.3at PoE) This patch was originally developed by Julien Dusser for the EAP245 v1, and was adapted by Sander Vanheule to support more devices. Signed-off-by: Julien Dusser <[email protected]> Signed-off-by: Sander Vanheule <[email protected]> --- .../dts/qca9563_tplink_eap2x5_1port.dtsi | 139 ++++++++++++++++++ target/linux/ath79/image/generic-tp-link.mk | 10 ++ 2 files changed, 149 insertions(+) create mode 100644 target/linux/ath79/dts/qca9563_tplink_eap2x5_1port.dtsi diff --git a/target/linux/ath79/dts/qca9563_tplink_eap2x5_1port.dtsi b/target/linux/ath79/dts/qca9563_tplink_eap2x5_1port.dtsi new file mode 100644 index 0000000000..24f0b4f0ce --- /dev/null +++ b/target/linux/ath79/dts/qca9563_tplink_eap2x5_1port.dtsi @@ -0,0 +1,139 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +#include "qca956x.dtsi" + +/ { + aliases { + label-mac-device = ð0; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "Reset button"; + linux,code = <KEY_RESTART>; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; +}; + +&pcie { + status = "okay"; +}; + +&uart { + status = "okay"; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x020000>; + read-only; + }; + + partition@20000 { + label = "partition-table"; + reg = <0x020000 0x010000>; + read-only; + }; + + info: partition@30000 { + label = "info"; + reg = <0x030000 0x010000>; + read-only; + }; + + partition@40000 { + compatible = "openwrt,elf"; + label = "firmware"; + reg = <0x040000 0xec0000>; + }; + + partition@f00000 { + label = "config"; + reg = <0xf00000 0x030000>; + read-only; + }; + + partition@f30000 { + label = "mutil-log"; + reg = <0xf30000 0x080000>; + read-only; + }; + + partition@fb0000 { + label = "oops"; + reg = <0xfb0000 0x040000>; + read-only; + }; + + art: partition@ff0000 { + label = "art"; + reg = <0xff0000 0x010000>; + read-only; + }; + }; + }; +}; + +&pinmux { + mdio_pins: pinux_mdio_pins { + /* GPIO 8 as MDC(0x21), GPIO 10 as MDIO(0x20) */ + pinctrl-single,bits = <0x8 0x00000021 0x000000ff>, + <0x8 0x00200000 0x00ff0000>; + }; +}; + +&mdio0 { + status = "okay"; + + pinctrl-names = "default"; + pinctrl-0 = <&mdio_pins>; + + phy-mask = <0x10>; + + phy4: ethernet-phy@4 { + reg = <4>; + reset-gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; +}; + +ð0 { + status = "okay"; + + phy-handle = <&phy4>; + phy-mode = "sgmii"; + + mtd-mac-address = <&info 0x8>; + + qca956x-serdes-fixup; + + gmac-config { + device = <&gmac>; + }; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&art 0x1000>; + mtd-mac-address = <&info 0x8>; +}; diff --git a/target/linux/ath79/image/generic-tp-link.mk b/target/linux/ath79/image/generic-tp-link.mk index 8a26e4bebe..d2cc8d09bd 100644 --- a/target/linux/ath79/image/generic-tp-link.mk +++ b/target/linux/ath79/image/generic-tp-link.mk @@ -362,6 +362,16 @@ define Device/tplink_cpe610-v2 endef TARGET_DEVICES += tplink_cpe610-v2 +define Device/tplink_eap2x5_1port + $(Device/tplink-safeloader) + SOC := qca9563 + IMAGE_SIZE := 15104k + LOADER_TYPE := elf + KERNEL := kernel-bin | append-dtb | lzma | loader-kernel + KERNEL_INITRAMFS := $$(KERNEL) + IMAGE/factory.bin := append-rootfs | tplink-safeloader factory | pad-extra 128 +endef + define Device/tplink_eap245-v3 $(Device/tplink-safeloader) SOC := qca9563 -- 2.26.2 _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
