> -----Original Message----- > From: openwrt-devel [mailto:[email protected]] > On Behalf Of Sorin Pop > Sent: Sonntag, 6. Dezember 2020 00:54 > To: [email protected] > Subject: ramips: add support for Xiaomi Mi Router 4AC (100M Edition) > > - SoC: MediaTek MT7628AN > - Flash: 16MB (Winbond W25Q128JV) > - RAM: 64MB > - Serial: As marked on PCB, 3V3 logic, baudrate is 115200 > - Ethernet: 3x 10/100 Mbps (switched, 2x LAN + WAN) > - WIFI0: MT7628AN 2.4GHz 802.11b/g/n > - WIFI1: MT7612EN 5GHz 802.11ac > - Antennas: 4x external (2 per radio), non-detachable > - LEDs: Programmable power-LED (two-colored, yellow/blue) > Non-programmable internet-LED (shows WAN-activity) > - Buttons: Reset
So, the only difference in implementation is the size of overlay/firmware partitions? Best Adrian > > INSTALLATION: > > 1. Connect to the serial port of the router and power it up. > If you get a prompt asking for boot-mode, go to step 3. > 2. Unplug the router after > > Erasing SPI Flash... > > raspi_erase: offs:20000 len:10000 > occurs on the serial port. Plug the router back in. > 3. At the prompt select option 2 (Load system code then > write to Flash via TFTP.) > 4. Enter 192.168.1.1 as the device IP and 192.168.1.2 as the > Server-IP. > 5. Connect your computer to LAN1 and assign it as 192.168.1.2/24. > 6. Serve the sysupgrade image via TFTP > > This router seems to have the same hardware as Xiaomi Mi Router 4A (100M > Edition) but it uses a different U-Boot. > > Signed-off-by: Sorin Pop <[email protected]>
openpgp-digital-signature.asc
Description: PGP signature
_______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
