On 30.11.2022 12:53, Jan-Niklas Burfeind wrote:
On 11/30/22 10:41, Arınç ÜNAL wrote:
On 30.11.2022 12:33, Jan-Niklas Burfeind wrote:
Wavlink WS-WN572HP3 4G is an 802.11ac
dual-band outdoor router with LTE support.
Specifications;
* Soc: MT7621DAT
* RAM: 128MiB
* Flash: NOR 16MiB GD-25Q128ESIG3
* Wi-Fi:
* MT7613BEN: 5GHz
* MT7603EN: 2.4GHz
* Ethernet: 2x 1GbE
* USB: None - only used internally
* LTE Modem: Quectel EC200T-EU
* UART: 115200 baud
* LEDs:
* 7 blue at the front
* 1 Power
* 2 LAN / WAN
* 1 Status
* 3 RSSI (annotated 4G)
* 1 green at the bottom (4G LED)
* Buttons: 1 reset button
Installation:
* press and hold the reset button while powering on the device
* keep it pressed for ten seconds
* connect to 192.168.10.1 via webbrowser (chromium/chrome works, at
least Firefox 106.0.3 does not)
* upload the sysupgrade image, confirm the checksum, wait 2 minutes
until the device reboots
Revert to stock firmware:
* same as installation but use the recovery image for WL-WN572HP3
Signed-off-by: Jan-Niklas Burfeind <[email protected]>
Acked-by: Arınç ÜNAL <[email protected]>
Arınç
Something must've gone wrong.
Connecting the lan port does not trigger a log message anymore.
WAN still does:
982.295568] mtk_soc_eth 1e100000.ethernet wan: Link is Up - 1Gbps/Full -
flow control rx/tx
Arınç: Could you have a look at the diff, whether I deleted the node in
the way you intended?
Not sure what I'm missing now; worked before.
Your compatible string on the DT is wavlink,ws-wn572hp3-4g but you put
wavlink,ws-wn572hp3 on 02_network. You should fix this and if it still
won't work, attach the bootlog.
Arınç
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
