The sender domain has a DMARC Reject/Quarantine policy which disallows
sending mailing list messages using the original "From" header.
To mitigate this problem, the original message has been wrapped
automatically by the mailing list software.
--- Begin Message ---
Hi.
On 11/02/2026 14:00, Caleb James DeLisle wrote:
Then question is: If we implement a pass-through switch, is that a
different driver? I guess it doesn't register as DSA. What is it in
the DT? Do we still reset it and tune TRGMII? Would need to copy:
mt7530_setup_port6, mt7530_setup_port5, all of the MDIO bus stuff
(mt7531_ind_c22_phy_read, mt7531_ind_c22_phy_write), and some of
mt7530_setup.
Not sure about the TRGMII part, there I would say copy the vendor driver
logic that has been stable enough for shipping devices. But a driver for
the MMIO switch is needed because of the mdio interface.
Maybe different compatible strings for mcm-host mode that only setups up
the pass-through and mdio? Then the actually used MCM switch should look
like the mt7621 dts.
MvH
Benjamin Larsson
--- End Message ---
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
