#10045: wifi detect doesn't output anything
----------------------------------+-----------------------------------
Reporter: vhann3000+openwrt@… | Owner: developers
Type: defect | Status: reopened
Priority: normal | Milestone: Barrier Breaker 14.07
Component: packages | Version: Trunk
Resolution: | Keywords:
----------------------------------+-----------------------------------
Changes (by dioo_):
* status: closed => reopened
* resolution: worksforme =>
Comment:
Hi, after a long while putting this device away, I'm back at it.
Both of the following attempts are with Chaos Calmer r45227:
I tried the Broadcom proprietary driver with jow's help on IRC (disabling
everything else, etc), but it didn't work: wl and wl_glue are loaded in
lsmod, but no wireless in ifconfig -a.
Then I reread Zajec's comment above and tried the following:
1. select b43 (CONFIG_TARGET_brcm47xx_legacy_Broadcom-b43)
2. Disable all Broadcom stuff: (kmod-brcm-wl, kmod-brcm-wl-mini)
3. Enable kmod-b43
4. Set CONFIG_B43_FW_SQUASH_PHYTYPES to G,LP,N (added N)
5. Enable CONFIG_PACKAGE_B43_PHY_N
6. Enable CONFIG_PACKAGE_B43_DEBUG
Still no luck:
{{{
root@OpenWrt:~# dmesg | egrep 'ssb|bcma|b43'
[ 0.000000] bcm47xx: using ssb bus
[ 0.000000] ssb: Found chip with id 0x4704, rev 0x09 and package 0x00
[ 0.000000] ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x03, vendor
0x4243)
[ 0.000000] ssb: Core 1 found: Fast Ethernet (cc 0x806, rev 0x06,
vendor 0x4243)
[ 0.000000] ssb: Core 2 found: Fast Ethernet (cc 0x806, rev 0x06,
vendor 0x4243)
[ 0.000000] ssb: Core 3 found: USB 1.1 Hostdev (cc 0x808, rev 0x03,
vendor 0x4243)
[ 0.000000] ssb: Core 4 found: PCI (cc 0x804, rev 0x08, vendor 0x4243)
[ 0.000000] ssb: Core 5 found: MIPS 3302 (cc 0x816, rev 0x03, vendor
0x4243)
[ 0.000000] ssb: Core 6 found: V90 (cc 0x807, rev 0x02, vendor 0x4243)
[ 0.000000] ssb: Core 7 found: IPSEC (cc 0x80B, rev 0x00, vendor
0x4243)
[ 0.000000] ssb: Core 8 found: MEMC SDRAM (cc 0x80F, rev 0x02, vendor
0x4243)
[ 0.000000] ssb: chipcommon status is 0x0
[ 0.000000] ssb: Initializing MIPS core...
[ 0.000000] ssb: set_irq: core 0x0806, irq 4 => 4
[ 0.000000] ssb: set_irq: core 0x0806, irq 5 => 5
[ 0.000000] ssb: after irq reconfiguration
[ 0.000000] ssb: core 0x0800, irq : 2(S) 3* 4 5 6 D I
[ 0.000000] ssb: core 0x0806, irq : 2(S) 3 4* 5 6 D I
[ 0.000000] ssb: core 0x0806, irq : 2(S) 3 4 5* 6 D I
[ 0.000000] ssb: core 0x0808, irq : 2(S)* 3 4 5 6 D I
[ 0.000000] ssb: core 0x0804, irq : 2(S) 3 4 5 6* D I
[ 0.000000] ssb: core 0x0816, irq : 2(S)* 3 4 5 6 D I
[ 0.000000] ssb: core 0x0807, irq : 2(S)* 3 4 5 6 D I
[ 0.000000] ssb: core 0x080b, irq : 2(S)* 3 4 5 6 D I
[ 0.000000] ssb: core 0x080f, irq : 2(S) 3 4 5 6 D I*
[ 0.000000] ssb: Sonics Silicon Backplane found at address 0x18000000
[ 0.770000] b44 ssb0:0: attached PHY driver [Broadcom B53 (1)]
(mii_bus:phy_addr=1:1e)
[ 0.780000] b44 ssb0:0 eth0: Broadcom 44xx/47xx 10/100 PCI ethernet
driver 00:18:f8:e6:18:f8
[ 0.800000] b44 ssb0:1: could not find PHY at 4, use fixed one
[ 0.800000] b44 ssb0:1: attached PHY driver [Generic PHY]
(mii_bus:phy_addr=fixed-0:00)
[ 0.810000] b44 ssb0:1 eth1: Broadcom 44xx/47xx 10/100 PCI ethernet
driver 00:88:88:88:00:2a
[ 4.640000] b44 ssb0:0 eth0: Link is up at 100 Mbps, half duplex
[ 4.650000] b44 ssb0:0 eth0: Flow control is off for TX and off for RX
[ 5.780000] b44 ssb0:0 eth0: Link is Up - 100Mbps/Full - flow control
off
[ 15.410000] b44 ssb0:0 eth0: powering down PHY
[ 15.780000] b44 ssb0:0 eth0: Link is Down
[ 26.560000] b44 ssb0:0 eth0: Link is up at 100 Mbps, full duplex
[ 26.570000] b44 ssb0:0 eth0: Flow control is off for TX and off for RX
[ 27.790000] b44 ssb0:0 eth0: Link is Up - 100Mbps/Full - flow control
off
[ 35.270000] b44 ssb0:0 eth0: powering down PHY
[ 35.310000] b44 ssb0:0 eth0: Link is up at 100 Mbps, full duplex
[ 35.320000] b44 ssb0:0 eth0: Flow control is off for TX and off for RX
[ 35.420000] b44 ssb0:1 eth1: Link is up at 100 Mbps, half duplex
[ 35.430000] b44 ssb0:1 eth1: Flow control is off for TX and off for RX
[ 36.890000] b44 ssb0:1 eth1: Link is Up - 100Mbps/Full - flow control
off
root@OpenWrt:~#
}}}
{{{
root@OpenWrt:~# lsmod | head -n 4
arc4 1312 0
b43 356356 0
cfg80211 213249 2 b43
compat 1628 3 b43
root@OpenWrt:~#
}}}
--
Ticket URL: <https://dev.openwrt.org/ticket/10045#comment:10>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets
