#21284: EA3500 (Audi Kirkwood) wifi unstable.
------------------------+---------------------------------------
  Reporter:  anonymous  |      Owner:  developers
      Type:  defect     |     Status:  new
  Priority:  normal     |  Milestone:  Designated Driver (Trunk)
 Component:  kernel     |    Version:  Trunk
Resolution:             |   Keywords:
------------------------+---------------------------------------

Comment (by BenjaminH):

 Same issue here, 5ghz works fine. 2.4 Ghz fails. Relevant kernel log (most
 relevant starting 298.558331):
 {{{
 [    7.649446] Marvell TOPDOG(R) 802.11 Wireless Network Driver version
 0.13
 [    7.656340] pci 0000:00:01.0: enabling device (0140 -> 0142)
 [    8.373708] ieee80211 phy0: Command RF_ANTENNA error 0x2
 [    8.379095] ieee80211 phy0: failed to set # of RX antennas
 [    8.384642] ieee80211 phy0: Command RF_ANTENNA error 0x2
 [    8.390003] ieee80211 phy0: failed to set # of TX antennas
 [    8.395546] ieee80211 phy0: 88w8366 v48, 20aa4b7e3281, STA firmware
 4.1.0.3
 [    8.406269] pci 0000:00:02.0: enabling device (0140 -> 0142)
 [    9.066300] ieee80211 phy1: Command RF_ANTENNA error 0x2
 [    9.071650] ieee80211 phy1: failed to set # of RX antennas
 [    9.077224] ieee80211 phy1: Command RF_ANTENNA error 0x2
 [    9.082567] ieee80211 phy1: failed to set # of TX antennas
 [    9.088115] ieee80211 phy1: 88w8366 v48, 20aa4b7e3283, STA firmware
 4.1.0.3
 [   17.403926] ieee80211 phy1: 88w8366 v7, 20aa4b7e3283, AP firmware
 5.2.8.17
 [   17.452398] IPv6: ADDRCONF(NETDEV_UP): wlan1: link is not ready
 [   17.459930] device wlan1 entered promiscuous mode
 [   20.855368] IPv6: ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready
 [  260.456672] ieee80211 phy1: tx rings drained
 [  298.558331] 0000:01:00.0: unable to load firmware helper image
 [  298.564274] ieee80211 phy0: Cannot start firmware
 [  298.569109] ieee80211 phy0: Trying to reload the firmware again
 [  299.036221] ieee80211 phy0: 88w8366 v7, 20aa4b7e3281, AP firmware
 5.2.8.17
 [  299.085116] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
 [  299.089917] device wlan0 entered promiscuous mode
 [  299.105871] device wlan0 left promiscuous mode
 [  299.105971] br-lan: port 3(wlan0) entered disabled state

 }}}

--
Ticket URL: <https://dev.openwrt.org/ticket/21284#comment:21>
OpenWrt <http://openwrt.org>
Opensource Wireless Router Technology
_______________________________________________
openwrt-tickets mailing list
openwrt-tickets@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-tickets

Reply via email to