----- Original Message ----- > From: "Weedy" <[email protected]> > At this point check lspci and dmesg to see if it even thinks there is > wifi hardware. And lsmod to see if the driver is loaded. lspci doesn't appear to be installed and I ran out of time to install it.
The pertinent part of dmesg is below: b44.c:v2.0 eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:18:f8:d7:bb:35 b44: eth1: PHY Reset would not complete. eth1: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:88:88:88:00:2a BCM47xx Watchdog Timer enabled (30 seconds, nowayout) TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <[email protected]> All bugs added by David S. Miller <[email protected]> VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing unused kernel memory: 136k freed Please be patient, while OpenWrt loads ... diag: Detected 'Linksys WRT160N' b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is off for TX and off for RX. roboswitch: Probing device eth0: found a 5325! It's a 5350. mini_fo: using base directory: / mini_fo: using storage directory: /overlay b44: eth0: powering down PHY b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is off for TX and off for RX. device eth0 entered promiscuous mode br-lan: port 1(eth0) entering forwarding state b44: eth1: Link is up at 100 Mbps, full duplex. b44: eth1: Flow control is off for TX and off for RX. b44: eth1: powering down PHY b44: eth1: Link is up at 100 Mbps, full duplex. b44: eth1: Flow control is off for TX and off for RX. br-lan: port 1(eth0) entering disabled state br-lan: port 1(eth0) entering forwarding state Compat-wireless backport release: compat-wireless-2011-11-08-1-g4ab9b62 Backport based on wireless-testing.git master-2011-11-15 cfg80211: Calling CRDA to update world regulatory domain cfg80211: World regulatory domain updated: cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) Broadcom 43xx driver loaded [ Features: PL ] Broadcom 43xx-legacy driver loaded [ Features: PLID ] PPP generic driver version 2.4.2 Aaron Z _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-users
