Hello
I'm using Ubiquitity Airgrid M5 with Backfire 10.03.1 final (r29592)
I need to set ethernet speed to 10mbps half-duplex because I have
inteferences
with radio frequenci 96.6MHz and cannot connect to Hw.
I see that this hw is using ag71xx driver (dmesg output)
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth0: using fixed link parameters
Atheros AR71xx hardware watchdog driver version 0.1.0
ar71xx-wdt: timeout=15 secs (max=22)
and I see that there is a ag71xx_ethtool interface in source of this driver
but nevertheless compiled ethtool does not work
output of ethtool eth0
Settings for eth0:
Cannot get device settings: No such device
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err
tx_err
Link detected: yes
So what's the clue? How can I set linkspeed and duplex settings?
I tried also robocfg but of course does not work ...
Any hints?
Greetings and thanks
Beat
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-users
