Hi,
I have a device which produces the attached outputs when I run the names as
commands. How can I make OpenWrt run on this device?
Thanks in advance;
Erdem
Linux version 2.6.22 (can.ilhan@dalek-sec) (gcc version 4.2.3) #4 Tue Jun 7
14:58:54 EEST 2011
CPU revision is: 00019740
Found a 8MB ST compatible serial flash
Determined physical RAM map:
memory: 07fff000 @ 00000000 (usable)
Entering add_active_range(0, 0, 32767) 0 entries of 256 used
Zone PFN ranges:
Normal 0 -> 32767
HighMem 32767 -> 32767
early_node_map[1] active PFN ranges
0: 0 -> 32767
On node 0 totalpages: 32767
Normal zone: 0 pages used for memmap
Normal zone: 0 pages reserved
Normal zone: 32767 pages, LIFO batch:7
HighMem zone: 0 pages used for memmap
Built 1 zonelists. Total pages: 32767
Kernel command line: root=/dev/mtdblock5 console=ttyS0,115200
mtdparts=sflash:0x30000(cfe),0x10000(nvram),0x10000(Config),0x10000(ASD),0x200000(Kernel),-(RootFS)
Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, linesize 32 bytes.
Synthesized TLB refill handler (20 instructions).
Synthesized TLB load handler fastpath (32 instructions).
Synthesized TLB store handler fastpath (32 instructions).
Synthesized TLB modify handler fastpath (31 instructions).
PID hash table entries: 512 (order: 9, 2048 bytes)
CPU: BCM4716 rev 1 at 354 MHz
Using 177.000 MHz high precision timer.
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 125440k/131068k available (2789k kernel code, 5468k reserved, 594k
data, 132k init, 0k highmem)
Calibrating delay loop... 175.61 BogoMIPS (lpj=87808)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Using membase 8000000
PCI: Disabled
PCI: Fixing up bus 0
PCI: Fixing up bus 1
Time: MIPS clocksource has been installed.
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
fuse init (API version 7.9)
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.1.1.1 $ 4 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A
loop: module loaded
PPP generic driver version 2.4.2
NET: Registered protocol family 24
6 cmdlinepart partitions found on MTD device sflash
Found 6 partitions
Creating 6 MTD partitions on "sflash":
0x00000000-0x00030000 : "cfe"
0x00030000-0x00040000 : "nvram"
0x00040000-0x00050000 : "Config"
0x00050000-0x00060000 : "ASD"
0x00060000-0x00260000 : "Kernel"
0x00260000-0x00800000 : "RootFS"
Creating 1 MTD partitions on "sflash":
0x00000000-0x00800000 : "FlashAll"
PCI: Setting latency timer of device 0000:00:04.1 to 64
ehci_hcd 0000:00:04.1: EHCI Host Controller
ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000
ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver
PCI: Setting latency timer of device 0000:00:04.0 to 64
ohci_hcd 0000:00:04.0: OHCI Host Controller
ohci_hcd 0000:00:04.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:04.0: irq 5, io mem 0x18009000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
usbcore: registered new interface driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
nf_conntrack version 0.5.0 (1023 buckets, 8184 max)
BCM fast NAT: INIT
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <[email protected]>
All bugs added by David S. Miller <[email protected]>
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 132k freed
Algorithmics/MIPS FPU Emulator v1.5
air_msg: module license 'Proprietary' taints kernel.
AirTies Userspace-Kernelspace Messaging Framework
Bilal Hatipoglu <[email protected]> - June, 2010
PCI: Setting latency timer of device 0000:00:02.0 to 64
eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.134.0
wl: no version for "air_msg_socket_free" found: kernel tainted.
PCI: Setting latency timer of device 0000:00:01.0 to 64
[wlc_phy_shared_attach] Setting FAST_TIMER[15]
[wlc_phy_shared_attach] Setting SLOW_TIMER[60]
[wlc_phy_shared_attach] Setting GLACIAL_TIMER[120]
**********************
* STBC NOT ENABLED *
********************** (wlc_stf_ss_stbc_attach)
LQ: initializated (queue_size=4096)
wl0: Broadcom BCM4328 802.11 Wireless Controller 5.10.144.0 (WLTEST)
st: stream detection version 1.0
wv_classify: content classification and tagging support module
wv_classify: version 1.0
st: client attached
wv: Content aware multi-queue eggress packet scheduler
wv: version 1.0
jitrem: Eggress packet scheduler for simulating non-jitter environment
jitrem: version 1.0
jitrem[eth0] delay 99999744ns limit 10000 correction 8
st: client attached
wv_classify: dev(eth0) is marked
igmp snoop module is loaded
device eth0 entered promiscuous mode
br0.1: port 1(eth0) entering learning state
br0.1: topology change detected, propagating
br0.1: port 1(eth0) entering forwarding state
device wl0 entered promiscuous mode
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
[wlc_rateset_filter_mcsset] env.var. 'wl_ratelimit' not found, using default
value [wl_ratelimit=0]
RateList[ MCS0 MCS1 MCS2 MCS3 MCS4 MCS5 MCS6 MCS7 MCS12 MCS13 MCS14 MCS15 ]
br0.1: port 2(wl0) entering learning state
br0.1: topology change detected, propagating
br0.1: port 2(wl0) entering forwarding state
device wds0.1 entered promiscuous mode
br0.1: port 2(wl0) entering disabled state
br0.1: port 2(wl0) entering learning state
br0.1: topology change detected, propagating
br0.1: port 2(wl0) entering forwarding state
br0.1: port 2(wl0) entering disabled state
br0.1: port 2(wl0) entering learning state
br0.1: topology change detected, propagating
br0.1: port 2(wl0) entering forwarding state
br0.1: port 3(wds0.1) entering learning state
br0.1: topology change detected, propagating
br0.1: port 3(wds0.1) entering forwarding state
WDS link 20:aa:4b:71:8c:0f going to pending state!
<6>br0.1: port 3(wds0.1) entering disabled state
br0.1: port 3(wds0.1) entering learning state
br0.1: topology change detected, propagating
br0.1: port 3(wds0.1) entering forwarding state
air_bridge_igmpsnoop 20480 0 - Live 0xc001a000
sch_jitrem 10320 1 - Live 0xc0038000
sch_wv 11856 2 - Live 0xc0026000
wv_classify 16336 2 sch_jitrem,sch_wv, Live 0xc0021000
stdetect 14352 2 sch_jitrem,wv_classify, Live 0xc0007000
wl 2125744 0 - Live 0xc02a0000 (PF)
et 48976 0 - Live 0xc002b000 (P)
air_led 9344 2 wl, Live 0xc0016000
air_env 5312 1 wl, Live 0xc0013000
air_mcast_early_drop 2208 0 - Live 0xc0005000
air_msg 21280 1 wl, Live 0xc000c000 (P)
Linux Air4420 2.6.22 #4 Tue Jun 7 14:58:54 EEST 2011 mips GNU/Linux
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-users
