I don't know about ipv6 from experience but a look around the wiki shows: HowTo for Backfire and Attitude Adjustment until 12.09 http://wiki.openwrt.org/doc/howto/ipv6
for Attitude Adjustment release 12.09.1 and later http://wiki.openwrt.org/doc/uci/network6 For system upgrade, I believe it depends on how you have it configured and if you use the luci (web interface) vs sysupgrade (at linux command line) to do the upgrade. I can't seem to find any documentation on the luci side really... For sysupgrade via CLI, see http://wiki.openwrt.org/doc/howto/generic.sysupgrade For luci, it seems like the the configuration in uci luci.flash_keep is what is needed. But I can't find this documented in wiki anywhere The general idea with either method - is that-- by default, configuration of the basic options are generally carried over. If you have custom configurations they may not be. hth On Thu, May 1, 2014 at 9:02 PM, John Griessen <[email protected]> wrote: > Hi, > > I just installed attitude adjustment on a tp-link wdr4300 with no obvious > problems. > What will it take to enable IPv6 on it? > > When you load a system upgrade firmware, does that save settings? > > How close to releasable is barrier breaker? > > John Griessen > _______________________________________________ > openwrt-users mailing list > [email protected] > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
