Hi,
I recently updated from r45770 to r46496 and noticed that the kernel
changed from 3.18.14 to 4.1.3. Unfortunally the AP does no longer boot
and I had to restore the old firmware via uboot console. Please find
the log which was printed on tty below. Any idea what could be done to
fix this? Anything more I can do? Anything else where I should report
this to?
By the way.... I had to drop the installation of snmpd-static because
the image got to big :((((
U-Boot 1.1.4 (Jul 15 2010 - 12:16:03)
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
id read 0x100000ff
flash size 4MB, sector count = 64
Flash: 4 MB
Using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
No valid address in Flash. Using fixed address
bsingle_phy = 0
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
Uncompressing Kernel Image ... OK
Starting kernel ...
OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <[email protected]>
Looking for OpenWrt image... found at 0xbf022000
Decompressing kernel... done!
Starting kernel at 80060000...
[ 0.000000] Linux version 4.1.3 (olivleh1@tomate) (gcc version
4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r46496) ) #1 Sun Jul 26 17:07:17
CEST 2015
[ 0.000000] bootconsole [early0] enabled
[ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc)
[ 0.000000] SoC: Atheros AR9132 rev 2
[ 0.000000] Determined physical RAM map:
[ 0.000000] memory: 02000000 @ 00000000 (usable)
[ 0.000000] Initrd not found or empty - disabling initrd
[ 0.000000] Zone ranges:
[ 0.000000] Normal [mem 0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Movable zone start for each node
[ 0.000000] Early memory node ranges
[ 0.000000] node 0: [mem 0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Initmem setup node 0 [mem
0x0000000000000000-0x0000000001ffffff]
[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
[ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases,
linesize 32 bytes
[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on.
Total pages: 8128
[ 0.000000] Kernel command line: rootfstype=squashfs,jffs2 noinitrd
[ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
[ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[ 0.000000] Writing ErrCtl register=00000000
[ 0.000000] Readback ErrCtl register=00000000
[ 0.000000] Memory: 28588K/32768K available (2545K kernel code,
125K rwdata, 348K rodata, 236K init, 184K bss, 4180K reserved, 0K
cma-reserved)
[ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
[ 0.000000] NR_IRQS:83
[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:100.000MHz,
Ref:5.000MHz
[ 0.000000] clocksource MIPS: mask: 0xffffffff max_cycles:
0xffffffff, max_idle_ns: 9556302233 ns
[ 0.000013] sched_clock: 32 bits at 200MHz, resolution 5ns, wraps
every 10737418237ns
[ 0.007809] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[ 0.090442] pid_max: default: 32768 minimum: 301
[ 0.095183] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.101700] Mountpoint-cache hash table entries: 1024 (order: 0,
4096 bytes)
[ 0.111816] clocksource jiffies: mask: 0xffffffff max_cycles:
0xffffffff, max_idle_ns: 19112604462750000 ns
[ 0.122271] NET: Registered protocol family 16
[ 0.127984] MIPS: machine is Generic AR71XX/AR724X/AR913X based board
[ 0.145730] Switched to clocksource MIPS
[ 0.150922] NET: Registered protocol family 2
[ 0.156571] TCP established hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.163461] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[ 0.169811] TCP: Hash tables configured (established 1024 bind 1024)
[ 0.176218] UDP hash table entries: 256 (order: 0, 4096 bytes)
[ 0.181969] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[ 0.188493] NET: Registered protocol family 1
[ 0.193832] futex hash table entries: 256 (order: -1, 3072 bytes)
[ 0.220641] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[ 0.226433] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME)
(CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[ 0.238479] io scheduler noop registered
[ 0.242308] io scheduler deadline registered (default)
[ 0.247683] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[ 0.254497] console [ttyS0] disabled
[ 0.278043] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11,
base_baud = 625000) is a 16550A
_______________________________________________
openwrt-users mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-users
