Thanks Alf for the explanation. If I want to replace the current solver with a custom one, where is a good place to start with? Is NewtonIterationBlackoilInterleaved.cpp where the solvers are actually defined?
Regards Kang On Mon, Aug 14, 2017 at 4:18 AM, Alf Birger Rustad <a...@statoil.com> wrote: > Hi Kang, > > > The short answer is that flow does not support running the model yet. The > long answer is that SPE10 Model 2 is a two-phase upscaling study, and hence > by nature not fond of the preconditioning routines used by default in flow > (or some of the commercial simulators for that matter). The most obvious > remedy to this is to exploit the fact that SPE10 Model 2 is a two-phase > case, and to use algebraic multigrid based preconditioning. We just very > recently landed a true two-phase simulator version of flow, which actually > supports an AMG based linear solver. Adapting the deck to this reality may > finally make SPE10 Model 2 run well with flow. > > Cheers, > > Alf > > ------------------------------ > *Fra:* Opm <opm-boun...@opm-project.org> på vegne av Kangqiao Hu < > kangqia...@gmail.com> > *Sendt:* 14. august 2017 05:13 > *Til:* Opm@opm-project.org > *Emne:* [Opm] Typical Run-time for SPE10 > > Hi everyone, > > I am running spe10 model2 using flow with single thread on a Intel > i7-7820hk mobile processor, and the simulation has been running for more > than 4 days and it seems to be far from complete. I was wondering what is > the typical time of running this test case? Thanks! > > Regards > Kang > > > ------------------------------------------------------------------- > The information contained in this message may be CONFIDENTIAL and is > intended for the addressee only. Any unauthorized use, dissemination of the > information or copying of this message is prohibited. If you are not the > addressee, please notify the sender immediately by return e-mail and delete > this message. > Thank you >
_______________________________________________ Opm mailing list Opm@opm-project.org http://opm-project.org/cgi-bin/mailman/listinfo/opm