It seems a bit confusing what your real problem is but from this it
sounds like you have class-loading or dependency issue. Make sure there
is only one ConfigurationAdmin Service in your setup (e.g. activate the
console).
You might also want to adjust your Componetn config to require a
configuration. Also you should make sure that your Component behaves
right in the sense of the dynamic nature of OSGi, DS and CM...
If you describe a little more what your problem is (e.g. with a small
test-case) we can better help you. I have already used DS with
pax-exam-cm module without a problem.
Am 28.10.2016 12:17, schrieb Benson Margulies:
On Fri, Oct 28, 2016 at 12:23 AM, Christian Schneider
<[email protected]> wrote:
Do you set up the configuration programmatically using ConfigurationAdmin ?
If yes then you might want to try the pax exam cm Module.
I use that.
In the debugger, I can see that SCR does not see ConfigurationAdmin.
The ConfAdminListener in SCR is never called to notice the arrival of
the CA service. Yet the CA service is there; I can obtain a reference
to it in my test.
--
--
------------------
OPS4J - http://www.ops4j.org - [email protected]
---
You received this message because you are subscribed to the Google Groups "OPS4J" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
