Title: RE: SAME, WAFL and RAID
New one I heard at our local Oracle office :

 RAIP = Redundant Array of Independent Processors
 
 (Those guys were talking about NT Clustering... )
 
 
 
-----Original Message-----
From: Mohan, Ross [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, January 15, 2002 4:41 PM
To: Multiple recipients of list ORACLE-L
Subject: RE: SAME, WAFL and RAID

SAME = 'stripe and mirror everthing'
BHT = 'butylated hydroxytoluene'
-----Original Message-----
From: Deshpande, Kirti [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, January 15, 2002 5:29 PM
To: Multiple recipients of list ORACLE-L
Subject: RE: SAME, WAFL and RAID

Great ! Thanks for the info..
 
- Kirti
 
-----Original Message-----
From: Nick Wagner [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, January 15, 2002 3:49 PM
To: Multiple recipients of list ORACLE-L
Subject: RE: SAME, WAFL and RAID

good question...  RAID and WALF -- see below.   SAME... no idea...

RAID - (from http://www.uni-mainz.de/~neuffer/scsi/what_is_raid.html )
What does RAID stand for ?
In 1987, Patterson, Gibson and Katz at the University of California Berkeley, published a paper entitled "A Case for Redundant Arrays of Inexpensive Disks (RAID)" . This paper described various types of disk arrays, referred to by the acronym RAID. The basic idea of RAID was to combine multiple small, inexpensive disk drives into an array of disk drives which yields performance exceeding that of a Single Large Expensive Drive (SLED). Additionally, this array of drives appears to the computer as a single logical storage unit or drive.

The Mean Time Between Failure (MTBF) of the array will be equal to the MTBF of an individual drive, divided by the number of drives in the array. Because of this, the MTBF of an array of drives would be too low for many application requirements. However, disk arrays can be made fault-tolerant by redundantly storing information in various ways.

Five types of array architectures, RAID-1 through RAID-5, were defined by the Berkeley paper, each providing disk fault-tolerance and each offering different trade-offs in features and performance. In addition to these five redundant array architectures, it has become popular to refer to a non-redundant array of disk drives as a RAID-0 array.

WAFL (from the NetApp website)
The WAFL (Write Anywhere File Layout) file system and the following features deliver enterprise-class availability:
        Consistency points. Always a consistent file-system image on disk, even after unplanned shutdowns. Virtually eliminates the need to run time-consuming file-system checks.

        Snapshot technology. Snapshots are near-instantaneous, transparent, read-only, online copies of the active file systems. Up to 31 Snapshots can be maintained for each data volume. Users can quickly recover deleted or modified files without administrative assistance or restore from tape backup. The Snapshot function requires minimal disk space and causes no disruption of service. Snapshots can be backed up to other media while users are modifying the active file system to minimize business disruption.

        SnapRestore software. Allows any system to revert back to a specified data volume Snapshot for instant file-system recovery.    Terabytes can be recovered in minutes, rather than hours, without going to tape. The software also greatly facilitates scenario testing as well as providing disaster recovery and virus protection.

Easy, cost-effective clustering. Safeguards against hardware failures by automatic filer takeover. Gives users continuous access to data.

SnapMirror software. Provides remote mirroring at high speeds over a LAN or WAN. The asynchronous mirroring can be used for disaster recovery, replication, backup, or testing on a nonproduction system.

-----Original Message-----
From: Deshpande, Kirti [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, January 15, 2002 1:23 PM
To: Multiple recipients of list ORACLE-L
Subject: RE: SAME, WAFL and RAID


Good idea..

All I know about WAFL is the House where breakfast is served ;)

- Kirti

-----Original Message-----
Sent: Tuesday, January 15, 2002 2:57 PM
To: Multiple recipients of list ORACLE-L


May I make a suggestion?  It would be helpful if posters would expand
acronyms the first time they use them.  I, at least, have no idea what
WAFL is.  Thanks.


--- Bill Becker <[EMAIL PROTECTED]> wrote:
> Hello,
>
> I am looking for any pointers to white papers, etc.
> that discuss the differences/similarities among
> WAFL, SAME and RAID

__________________________________________________
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail!
http://promo.yahoo.com/videomail/
--
Please see the official ORACLE-L FAQ: http://www.orafaq.com
--
Author: Paul Baumgartel
  INET: [EMAIL PROTECTED]

Fat City Network Services    -- (858) 538-5051  FAX: (858) 538-5051
San Diego, California        -- Public Internet access / Mailing Lists
--------------------------------------------------------------------
To REMOVE yourself from this mailing list, send an E-Mail message
to: [EMAIL PROTECTED] (note EXACT spelling of 'ListGuru') and in
the message BODY, include a line containing: UNSUB ORACLE-L
(or the name of mailing list you want to be removed from).  You may
also send the HELP command for other information (like subscribing).
--
Please see the official ORACLE-L FAQ: http://www.orafaq.com
--
Author: Deshpande, Kirti
  INET: [EMAIL PROTECTED]

Fat City Network Services    -- (858) 538-5051  FAX: (858) 538-5051
San Diego, California        -- Public Internet access / Mailing Lists
--------------------------------------------------------------------
To REMOVE yourself from this mailing list, send an E-Mail message
to: [EMAIL PROTECTED] (note EXACT spelling of 'ListGuru') and in
the message BODY, include a line containing: UNSUB ORACLE-L
(or the name of mailing list you want to be removed from).  You may
also send the HELP command for other information (like subscribing).

Reply via email to