Setting DEBUG_UPDATE_RPMS to any value will enable debugging to appear
on the terminal whence install_cluster was run, e.g.,
DEBUG_UPDATE_RPMS= ./install_cluster <device>
The output will include the command line and the package names returned
to the caller. Note, I also display the needed rpm options, e.g., -ihv,
-Uhv, --nodeps, but these are not actually returned to the caller. In
addition, a couple of error conditions, that also set a return value,
are also reported via this option.
This might be useful if you suspect update-rpms failed to return correct
results.
--
David N. Lombard
My comments represent my opinions, not those of Intel Corporation.
-------------------------------------------------------
This SF.Net email is sponsored by Sleepycat Software
Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver
higher performing products faster, at low TCO.
http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3
_______________________________________________
Oscar-devel mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/oscar-devel
