After the desired MAC address shows up, click on it, then click on the node in the right pane to which you want to assign it. Then click "Assign MAC to node". Do this for any nodes you desire to use. Then click the "Configure DHCP Server" button. This is covered reasonably well in the Installation docs.
Good luck, Vann On Thu, 2002-12-12 at 03:05, [EMAIL PROTECTED] wrote: > Dear helper: > > I am new here and I had a problem to install oscar 2.0. > I try to build a cluster myself. I was confused on step 6 setup networking. > I was able to collect mac, then I "stop collecting" and click > "configure DHCP server". After that I am not sure what to do next so I > tried click "setup network boot" and switch to my client node and > started PXE again. However no matter what I do, I cannot install > client. I also tried boot from floppy. The boot log is attached. > I have 3Com 3c905TMX NIC. > > Would you please help me on this one? What is the sequence I have to > do? When should I switch to client to second boot from network or > let the first network boot rnning? > > Thanks for help and best regards > RX ------------------------------------------------------- This sf.net email is sponsored by: With Great Power, Comes Great Responsibility Learn to use your power at OSDN's High Performance Computing Channel http://hpc.devchannel.org/ _______________________________________________ Oscar-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/oscar-users
