Hi all,
This is probably an easy question. I have a collection of absolutely
gigantic OpenInventor files. I would like to load and display only a
tiny portion of the geometry, clipped by a bounding box. In the past I
would have simply setup hardware clipping planes to accomplish this.
But in this case, I would rather not send a massive amount of geometry
down the pipe, only to draw perhaps 1% of it.
I looked in osgUtil but didn't see the sort of software-based clipping
code I was looking for. Has someone done this already?
Chuck
----------------------------------------------------------------------
This e-mail, including any attached files, may contain confidential and
privileged information for the sole use of the intended recipient. Any review,
use, distribution, or disclosure by others is strictly prohibited. If you are
not the intended recipient (or authorized to receive information for the
intended recipient), please contact the sender by reply e-mail and delete all
copies of this message.
_______________________________________________
osg-users mailing list
[email protected]
http://openscenegraph.net/mailman/listinfo/osg-users
http://www.openscenegraph.org/
