Earlier, Karsten Thomann wrote, in part: > I don't know if i have missed that part, but what would happen if OSPFv3 > is running over IPv4 and there are two (or more) IPv6 Islands already > deployed > within the network, should there be any LSA flooding checks, like do not > flood > LSA with IPv6 networks over IPv4 only links, or should the route > calculation/installation of the information simply fail > as there is no valid path?
The OSPF deployments I am familiar with did not "auto deploy" or "self deploy". Instead, all of the OSPF deployments that I am familiar with had engineers making deliberate decisions about how to configure the OSPF deployment, and also how to configure the OSPF routers in that deployment. One deployment option, already deployed in some places, is to run "ships in the night". In this model, the IPv4 topology exclusively uses OSPFv2 over IPv4 and the IPv6 topology exclusively uses OSPFv3 over IPv6. For some sites, that is a good option. A number of my clients are very interested in this new I-D because it optimises their IPv6 transition strategy. For some sites, IPv6 transition is simplified, optimised, and also cost-reduced by using OSPFv3 over IPv4 initially, and carrying both IPv4 prefixes and IPv6 prefixes inside that one OSPFv3 deployment (i.e. using the Address Family extension to keep the prefixes clearly differentiated within a single OSPFv3 deployment). This can lower operational costs because one can get by with managing only OSPFv3, rather than having to manage both OSPFv2 and OSPFv3. If one's "IPv6 islands" (to use your term) are really dual-stack (aside: having dual-stack rather than IPv6-only would be expected and normal if another part of one's OSPF deployment is using OSPF over IPv4), then EITHER the whole deployment should be configured to run over IPv4 XOR the whole deployment should be configured to run over IPv6. Having different "IPv4 islands" and "IPv6 islands" is an explicit choice of a configuration engineer or design engineer. That probably is not the optimal deployment choice for an engineer to make. It definitely is NOT a choice that I would make or that I would recommend to my clients. >From the descriptions and definitions in the draft, it would not be "normal" or "expected" to mix IPv6 transport with IPv4 transport within a single OSPFv3 deployment. > Is there any explicit preference over which version the adjacency > is build if v4 and v6 is available in that specific part of the network? The choice of preferred OSPF transport really is something that the configuration engineer ought to configure. As the details of configuring any IP router are outside the scope of the IETF, I am not sure that this I-D properly can or should say very more than it already says. Perhaps the I-D could add clarifying text along these lines somewhere in Section 2: "Implementers of OSPFv3 over IPv4 SHOULD add a configuration knob to let the router administrator select whether a given OSPFv3-enabled interface should use OSPFv3 over IPv4 or OSPFv3 over IPv6. Except when an OSPFv3 deployment is being transitioned from using IPv4 transmission to using IPv6 transmission, it is RECOMMENDED that all routers within an OSPFv3 deployment use the same IP version for OSPFv3 packet transmission." > What should happen when an IPv4 Link gets v6 added, graceful reestablish > the adjacency over IPv6, or wait until forced protocol switch? See my answer just above. I would expect that any router that implements this I-D also would implement a configuration knob to indicate whether IPv4 transmission or IPv6 transmission is preferred. Over time, a configuration engineer might change this (e.g. manually change from IPv4 transmission to IPv6 transmission AFTER an entire IPv4 network has been deployed-with/converted-to dual-stack IPv4 and IPv6). Yours, Ran Atkinson _______________________________________________ OSPF mailing list [email protected] https://www.ietf.org/mailman/listinfo/ospf
