On Thu, Dec 2, 2021 at 12:20 PM Cpp Code <[email protected]> wrote: > > On Wed, Dec 1, 2021 at 11:34 PM Pravin Shelar <[email protected]> wrote: > > > > On Wed, Nov 24, 2021 at 11:33 AM Toms Atteka <[email protected]> wrote: > > > > > > This change adds a new OpenFlow field OFPXMT_OFB_IPV6_EXTHDR and > > > packets can be filtered using ipv6_ext flag. > > > > > > Signed-off-by: Toms Atteka <[email protected]> > > > --- > > > include/uapi/linux/openvswitch.h | 6 ++ > > > net/openvswitch/flow.c | 140 +++++++++++++++++++++++++++++++ > > > net/openvswitch/flow.h | 14 ++++ > > > net/openvswitch/flow_netlink.c | 26 +++++- > > > 4 files changed, 184 insertions(+), 2 deletions(-) > > > > > > diff --git a/include/uapi/linux/openvswitch.h > > > b/include/uapi/linux/openvswitch.h > > > index a87b44cd5590..43790f07e4a2 100644 > > > --- a/include/uapi/linux/openvswitch.h > > > +++ b/include/uapi/linux/openvswitch.h > > > @@ -342,6 +342,7 @@ enum ovs_key_attr { > > > OVS_KEY_ATTR_CT_ORIG_TUPLE_IPV4, /* struct > > > ovs_key_ct_tuple_ipv4 */ > > > OVS_KEY_ATTR_CT_ORIG_TUPLE_IPV6, /* struct > > > ovs_key_ct_tuple_ipv6 */ > > > OVS_KEY_ATTR_NSH, /* Nested set of ovs_nsh_key_* */ > > > + OVS_KEY_ATTR_IPV6_EXTHDRS, /* struct ovs_key_ipv6_exthdr */ > > > > > > #ifdef __KERNEL__ > > > OVS_KEY_ATTR_TUNNEL_INFO, /* struct ip_tunnel_info */ > > > @@ -421,6 +422,11 @@ struct ovs_key_ipv6 { > > > __u8 ipv6_frag; /* One of OVS_FRAG_TYPE_*. */ > > > }; > > > > > > +/* separate structure to support backward compatibility with older user > > > space */ > > > +struct ovs_key_ipv6_exthdrs { > > > + __u16 hdrs; > > > +}; > > > + > > > struct ovs_key_tcp { > > > __be16 tcp_src; > > > __be16 tcp_dst; > > > diff --git a/net/openvswitch/flow.c b/net/openvswitch/flow.c > > > index 9d375e74b607..28acb40437ca 100644 > > > --- a/net/openvswitch/flow.c > > > +++ b/net/openvswitch/flow.c > > > @@ -239,6 +239,144 @@ static bool icmphdr_ok(struct sk_buff *skb) > > > sizeof(struct icmphdr)); > > > } > > > > > > +/** > > > + * get_ipv6_ext_hdrs() - Parses packet and sets IPv6 extension header > > > flags. > > > + * > > > + * @skb: buffer where extension header data starts in packet > > > + * @nh: ipv6 header > > > + * @ext_hdrs: flags are stored here > > > + * > > > + * OFPIEH12_UNREP is set if more than one of a given IPv6 extension > > > header > > > + * is unexpectedly encountered. (Two destination options headers may be > > > + * expected and would not cause this bit to be set.) > > > + * > > > + * OFPIEH12_UNSEQ is set if IPv6 extension headers were not in the order > > > + * preferred (but not required) by RFC 2460: > > > + * > > > + * When more than one extension header is used in the same packet, it is > > > + * recommended that those headers appear in the following order: > > > + * IPv6 header > > > + * Hop-by-Hop Options header > > > + * Destination Options header > > > + * Routing header > > > + * Fragment header > > > + * Authentication header > > > + * Encapsulating Security Payload header > > > + * Destination Options header > > > + * upper-layer header > > > + */ > > > +static void get_ipv6_ext_hdrs(struct sk_buff *skb, struct ipv6hdr *nh, > > > + u16 *ext_hdrs) > > > +{ > > > + u8 next_type = nh->nexthdr; > > > + unsigned int start = skb_network_offset(skb) + sizeof(struct > > > ipv6hdr); > > > + int dest_options_header_count = 0; > > > + > > > + *ext_hdrs = 0; > > > + > > > + while (ipv6_ext_hdr(next_type)) { > > > + struct ipv6_opt_hdr _hdr, *hp; > > > + > > > + switch (next_type) { > > > + case IPPROTO_NONE: > > > + *ext_hdrs |= OFPIEH12_NONEXT; > > > + /* stop parsing */ > > > + return; > > > + > > > + case IPPROTO_ESP: > > > + if (*ext_hdrs & OFPIEH12_ESP) > > > + *ext_hdrs |= OFPIEH12_UNREP; > > > + if ((*ext_hdrs & ~(OFPIEH12_HOP | OFPIEH12_DEST | > > > + OFPIEH12_ROUTER | > > > IPPROTO_FRAGMENT | > > > + OFPIEH12_AUTH | > > > OFPIEH12_UNREP)) || > > > + dest_options_header_count >= 2) { > > > + *ext_hdrs |= OFPIEH12_UNSEQ; > > > + } > > > + *ext_hdrs |= OFPIEH12_ESP; > > > + break; > > you need to check_header() before looking into each extension header. > > Could you elaborate why I need to add check_header(), > skb_header_pointer() is doing sanitization.
I mean check_header() would allow you to read the header without copying the bits, it is used in ovs flow extraction so its usual check. _______________________________________________ dev mailing list [email protected] https://mail.openvswitch.org/mailman/listinfo/ovs-dev
