There's something not quite right.... I'll have to get another 1W
system going to do anything else as right now I have to take down my
running system to troubleshoot this.
On 10/28/2014 4:40 PM, Jim Lill wrote:
I'm not quite working yet. Trying to use it is weewx and have to
figure out how to look at a specific port.
I may have to get owfs running again (weewx doesn't need it)
-Jim
On 10/26/2014 7:56 AM, Andrew Potter wrote:
Jim
I use both the EDS0083 (current) and EDS0082 (voltage) - both share
similar issues under my OWFS 2.9p5 installation. You're right, not
all data is reported, and not always in the right place.
The actual current is reported in min_current.X (not current.X)
I think the minimum recorded current is reported in current.X
max_current seems to be erratic and tends to consistently come back
at 0.031A in my setup -- not convinced that this real.
Also, I've had problems getting the alarms and min/max values to
reset using the alarm reset function.
Andrew
From: Jim Lill <j...@jimlill.com <mailto:j...@jimlill.com>>
Reply-To: "OWFS (One-wire file system) discussion and help"
<owfs-developers@lists.sourceforge.net
<mailto:owfs-developers@lists.sourceforge.net>>
Date: Sunday, 26 October 2014 8:17 pm
To: "OWFS (One-wire file system) discussion and help"
<owfs-developers@lists.sourceforge.net
<mailto:owfs-developers@lists.sourceforge.net>>
Subject: [Owfs-developers] EDS 4-ch A/1W board
I have a Embedded Data Systems
EDS 4-ch A/1W board, an EDS0083 I believe
and it is recognized but does not get all its data.
Anybody else using one?
-Jim
------------------------------------------------------------------------------
_______________________________________________
Owfs-developers mailing list
Owfs-developers@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/owfs-developers
