Hello Forum
I have a problem how to make the corosync config well
I have 2 networkinterfaces on each node (2 nodes)
One is for the normal network with ip failover (node1: 192.168.1.21
node2:192.168.1.22 failover ip 192.168.1.23
the other is a crossover cable for ring1 using drbd (node1 10.10.10.1
node2: 10.10.10.2)
Later i will work with *drbd with primary both *3 Luns as iscsi target
presented to an vmware virtual-center *
*
at the moment it looks on both node for interface eth0
rrp_mode none
interface {
ringnumber 0
bindnetaddr: 192.168.1.0
mcastaddr: 226.x.x.x
mcastport: xxxx
}
-------------------
now i want to add new ringnumber1 for interface eth1 (direct attached
crossover cable). i will make it like the follwing- but i don't know if
this is the correct way
node1:
rrp_mode active
interface {
ringnumber 0
bindnetaddr: 192.168.1.0
mcastaddr: 226.x.x.x
mcastport: xxxx
ringnumber 1
bindnetaddr: 10.10.10.0
}
node 2
rrp_mode passive
interface {
the same as node1
}
So can someone tell me it this is a correct config ??
Thanks Norbert
_______________________________________________
Pacemaker mailing list
Pacemaker@oss.clusterlabs.org
http://oss.clusterlabs.org/mailman/listinfo/pacemaker
