Hi once again,
using some sniffing ... the clear mac address table command is not
available on 2960X Ciscos.
*vttest#.clear mac-address-table interface Gi1/0/21 vlan 1 clear
mac-address-table interface Gi1/0/21 vlan 1
^ % Invalid input detected at '^' marker.*
Is there a way to disable this? Because pf does not set the linkDown trap -
I think because of this error.
Regards
Ronny
2016-07-12 11:59 GMT+02:00 Ronny Becker <[email protected]>:
> Hey again,
> I switched from SSH to telnet and the same error occurs :-/
> Tried to login via cli and telnet works, too.
>
> 2016-07-12 11:14 GMT+02:00 Ronny Becker <[email protected]>:
>
>> Hey,
>> packetfence has some problems on connecting to a cisco 2960 device.
>>
>> The log shows:
>> Jul 12 11:08:38 pfsetvlan(5) ERROR: ERROR: Can not connect to switch
>> 10.1.199.110 using SSH
>> (pf::Switch::Cisco::Catalyst_2950::clearMacAddressTable)
>>
>> Is there any switch to debug this, to get more information on this and
>> what the problem is?
>>
>> I tried to connect to this switch on cli and it works. So there is no
>> network problem.
>>
>> Regards
>> Ronny
>>
>>
>
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports.http://sdm.link/zohodev2dev
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users
