Hi,

I've set up packetfence to proxy 802.1x authentication requests to our NPS 
radius server in proxy.conf.  I can get the accept-accept back from the radius 
server, but I'm not sure how to get packetfence to assign the correct role/vlan 
after authentication.  Is there something that should be configured in the 
post-auth section of the sites-enabled/packetfence-tunnel config?  Or can 
packetfence not assign roles/vlans for proxied requests and the NPS need to be 
assigning the vlans?


Thanks and Regards,

Andrew Chung

[Compassion, Excellence, Reliability]<http://bhhc.co/BAYemail_site>


[Facebook]<http://bhhc.co/BAYemail_fb> [Twitter] <http://bhhc.co/BAYemail_tw>  
[LinkedIn] <http://bhhc.co/BAYemail_LI>  [YouTube] <http://bhhc.co/BAYemail_yt> 
 [Bayada] <http://bhhc.co/BAYemail_site>

CONFIDENTIALITY NOTICE: This email may contain information belonging to BAYADA 
and is protected by law. Do not forward, copy, or otherwise disclose to anyone 
unless permitted by BAYADA or required by law. If you are not the intended 
recipient, please notify the sender immediately.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users

Reply via email to