Hello ,
I have a Dell S3048ON Switch, on which I have some VLANs configured and also I
have configured 802.1X on a port which is connected to a local machine. The
switch configuration looks like below:
no ip address
switchport
no snmp trap link-status
spanning-tree rstp edge-port
dot1x authentication
dot1x tx-period 3
dot1x quiet-period 2
no shutdown
Now the Packetfence(on a sever machine) handles this switch and I have added
its properties in the switch and I am able to authenticate a local machine
based on the user I created in the Users Tab from Packetfence web interface.
I have specified the Role Mapping by Vlan ID on Switch config on Packetfence
and it looks like below:
Role by VLAN ID
Registration 10
isolation -
macDetection 4
inline -
default 2
guest 10
gaming -
voice -
REJECT 6
The enforcement on Packetfence is configured as VLAN-Enforcement.
Now I want to have three scenarios:
1) VLAN assignment (VLAN 10) before authentication for local machine
2) VLAN assignment (VLAN 2) on successful authentication
3) VLAN assignment (VLAN 6) on authentication failure
I have been successful for second scenario. But for 1st and 3rd scenario
VLAN-Assignment doesn't take place. So what else do I need to configure? I went
through the administration guide but still I am not able to come across any
solution.
Thank you.
Best regards,
Vijaykumar Rana
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
PacketFence-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/packetfence-users
