Where are you at in the process of setting up PF in your environment? The reason I ask is because this will vastly effect exactly what information you need at the moment.
>What is needed to be configured in PF? Nothing special, just add a switch as you would normally according to the PF documentation. >What is needed to be configured on client side? Its a macbook Nothing, MAB is transparent to the endpoint. >What is needed to be configured on the cisco 2960? Cisco has lots of documentation on configuring MAB. The specifics will be different depending on the version of IOS your switch is running. There is a global portion and also a per port portion. My global config: ============= aaa group server radius NAC server <PF IP HERE> auth-port 1812 acct-port 1813 ! aaa authentication dot1x default group NAC aaa authorization network default group NAC aaa accounting system default start-stop group NAC ! radius-server host <PF IP HERE> auth-port 1812 acct-port 1813 key <RADIUS SECRET HERE> radius-server vsa send authentication My port config: ============== interface GigabitEthernet1/0/4 switchport mode access switchport voice vlan <your VoIP vlan> authentication host-mode multi-domain authentication order mab authentication port-control auto mab mls qos trust cos spanning-tree portfast spanning-tree bpdufilter enable spanning-tree bpduguard enable spanning-tree guard loop ! Most of the port config is not MAB specific, just some good practices. That should get you started. Good luck! Post back to the list if you run into issues. Jake Sallee Godfather of Bandwidth System Engineer University of Mary Hardin-Baylor WWW.UMHB.EDU 900 College St. Belton, Texas 76513 Fone: 254-295-4658 Phax: 254-295-4221 ________________________________________ From: Wifi Guy via PacketFence-users <[email protected]> Sent: Monday, January 14, 2019 4:08 PM To: [email protected] Cc: Wifi Guy Subject: [PacketFence-users] Cisco 2960 802.1X and MAB Hi all, Can someone help with what is required to get wired 802.1X and/or MAB to work on wired clients connecting to a cisco 2960 switch? What is needed to be configured in PF? What is needed to be configured on client side? Its a macbook What is needed to be configured on the cisco 2960? Thanks _______________________________________________ PacketFence-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/packetfence-users
