hello, but apart from my problem, generally once you have created a vlan on
an interface, configured as inline, enable dhcp and nat on it, you don't
need to do anything else to make sure that it can be seen by traffic vlan
enabled on the ports of a switch and whose port connected to pf is
configured as tagged? Or do you need to do something else?
Thank you
In data 16 Agosto 2022 16:11:05 "Zammit, Ludovic" <luza...@akamai.com> ha
scritto:
Hello Leonardo,
Your issue is very specific and I would bet it’s configuration related.
I can tell you that it won’t be possible to do all the troubleshooting
steps here, it’s not a simple task.
However I can give you pointers to look at.
1- Eth0 need to be set as a Stat interface in the inline configuration
under Configuration > Network Configuration > Networks > inline > Snat
2- If I understand correctly, eth1 is a trunk interface where you have
added VLAN 11 on it. Can you ping from that interface another VLAN 11
interface in the network ? If yes, do some capture to make sure the VLAN 11
reach eth1.11 interface.
Use the commands:
ping -I eth1.11 1.2.3.4
ipset -S | less <— Check the ipset session, make sure where your Mac
address is at
ip route get 1.2.3.4
tcpdump -I eth1.11 port 67
Thanks,
Ludovic Zammit
Product Support Engineer Principal
Cell: +1.613.670.8432
Akamai Technologies - Inverse
145 Broadway
Cambridge, MA 02142
Connect with Us:
On Aug 16, 2022, at 4:27 AM, Leonardo Izzo I.T.S.
<leonardo.i...@itsinformatica.it> wrote:
Hi could you please answer? It is very important for my work. Thank you
--- Messaggio inoltrato ---
Da: leonardo.i...@itsinformatica.it
Data: 6 agosto 2022 17:32:00
Oggetto: static ip and dhcp on vlan interface
A: luza...@akamai.com
Cc: packetfence-users@lists.sourceforge.net
hi, I have Packetfence which is configured as follows:
It has 3 network cards: eth0 of type "other" which acts as wan, eth1 is LAN
interfaces and eth2 is of type "management".
The interfaces related to eth1 is configured as Inline.
My requirement is that for the subnet related to eth1, only a host with
static ip must go out on the Internet by pf. how do i configure this thing?
Also I have a wifi controller which assigns vlan 11 to all wifi traffic.
For this reason, on the eth1 interface I have created a vlan interface with
id: 11, also configured in Inline mode.
How come on this interface, pf does not intercept the wifi traffic with id:
11 by assigning ip addresses to it through dhcp and then obviously doing
the nat to go out on the Internet?
Thank you
_______________________________________________
PacketFence-users mailing list
PacketFence-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/packetfence-users
