Dino,
You can't run a PRC file from the desktop. You can only debug to POSE or
device, or build and then install it to the device.
Regards,
JK Lam
Metrowerks Technical Support
-----Original Message-----
From: Dinesh A.V. <[EMAIL PROTECTED]>
To: '[EMAIL PROTECTED]' <[EMAIL PROTECTED]>
Date: Tuesday, March 02, 1999 2:09 AM
Subject: RE: CW Project->Run menu item is disabled
>Chris,
>
>I tried that, but still it doesnt get enabled. Actually what is shown is
>a disabled 'Can't run' menu item. Any other suggestion?
>
>Dino
>
>>-----Original Message-----
>>From: [EMAIL PROTECTED] [SMTP:[EMAIL PROTECTED]]
>>Sent: Tuesday, March 02, 1999 1:09 PM
>>To: [EMAIL PROTECTED]
>>Subject: Re: CW Project->Run menu item is disabled
>>
>>Select Project->Remove Object Code
>>then the Run menu will be enabled
>>
>>Chris
>>
>>At 10:57 AM 3/2/99 +0530, you wrote:
>>>Hi,
>>>
>>>I just installed CW, and trying out some simple stuff. The
>>>Project->Run menu item in the IDE is disabled even after make.. Do I
>>>need to specifically do something have this item enabled? Please help
>>>
>>>TIA
>>>Dino
>>
>>---
>>Christian Vandendorpe ([EMAIL PROTECTED])
>>http://www.zorglub.com
>>
>
