Is HotSync turned off when you do this? Both CW and HotSync will use
the COM port exclusively when in use. So, you may need to shut down
HotSync to run CW if they are configured to use the same COM port.
As an aside, one thing I did was buy a spare cradle & serial port card
for my desktop. I put HotSync on one COM port and CW on the other.
Then I just place the palm in the cradle corresponding to the operation
I want to perform (sync vs. development).
Hope something in this helps...
Cheers,
Mike
> -----Original Message-----
> From: [EMAIL PROTECTED] [SMTP:[EMAIL PROTECTED]]
> Sent: Wednesday, April 14, 1999 9:27 AM
> To: [EMAIL PROTECTED]
> Subject: CW Lite and the Debugger
>
>
> All,
>
> I am using CW Lite (while I wait for my copy of CW) and I am working
> my way
> through the tutorial. I am trying to get the on device debugger
> working. I dbl click the .psym file, tap the [shortcut]..2
> strokes
> on the pilot and then press ok. I get an error message that says
> "Failed to connect to remote".
>
>
>
> does CW Lite have this feature turned off or is there something I am
> missing...
>
>
>
> thanks...
>
>
>
> mark
>
>
>
> BTW..I am using a SPT 1500 and it synchs with the palm desktop just
> fine.
>
>
>
