OK, so its finally gotten the better of me. I have two questions that I hope
one of you might be able to answer ...
Scenario 1 :
Have some code, compile it, run debug, finish running the code, THEN its hit
and miss at to whether or not I get the opportunity to go through the
change/compile/debug cycle again. Sometimes "debug" is an option on the
menu, sometimes it isn't ...
Anyone seen this before?
Scenario 2 :
Have some code, compile it, run debug, go to step through the code, but
there are no "stepping" controls and the code window is missing.
Ditto the above question.
Currently my painful solution is close CW, close my POSE (a5 release running
PalmOS 3.2 ROM if it helps), and then re open everything. This is slowing me
down to a crawl.
Please - constructive answers only. I have chosen my tools - I am not going
to start writing under a Linux environment, or start with GCC.
Regards,
CSE
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palm.com/devzone/mailinglists.html
