See KnowledgeBase article #1674.
http://oasis.palm.com/dev/kb/article.cfm?id=1674
Regards,
Steve
-----Original Message-----
From: Samuel Tu [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, June 28, 2000 1:44 PM
To: Palm Developer Forum
Subject: Using VC++ debug Conduit Question? Please Help
Hi Everyone,
I have a existing palm program and a customize conduit, I would like to
debug the conduit step by step in source level. However, after I follow the
conduit document from CDK to setup the VC++6, it just give me some
inspector information. What I really want is go inside the conduit line by
line. SoI load the prc into POSE and insert some data into my program
already,hotsync from POSE. Nothing happen....
Could you guys tell me how to use POSE debug the conduit? Or please give me
some information on this topic. Thanks alot.
Sam
============================================
Samuel Tu
Programmer
Numoda Corporation
The Curtis Center
601 Walnut Street, 9th Floor
Philadelphia, PA 19106
Tel : 215.238.8881
Fax : 215.238.9995
Email: [EMAIL PROTECTED]
---------------------------------------------------------------
This electronic mail transmission contain
confidential information intended only for
the person(s) named. Any use, distribution,
copying or disclosure by another person is
strictly prohibited.
---------------------------------------------------------------
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
