Viswa, You mentioned that you are using the serial port on the Palm Z22. Which pins in the MiniUSB connector are you using? (I would assume the Gnd, D+ and D-?) Did you design and build your own cable or purchase it some where?
Oh a side note, oh how I wish these Palms had USB OTG. The Z22's processor actually has a host controller built in if I read the processor's data sheet correctly but I don't think it is being used. /************************************************** Heath Schaefer Product Engineer Sporlan Division, Parker Hannifin Corporation 636.239.7711 x243 **************************************************/ "Dmitry Grinberg" <[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] 02/21/2008 05:05 AM Please respond to "Palm Developer Forum" <[email protected]> To "Palm Developer Forum" <[email protected]> cc Subject Re: Blank screen with reset button it's in the manual On 2/21/08, Viswanathan <[EMAIL PROTECTED]> wrote: > Yeah i am using 68k handler.. > Is it not reliable. May i know how u guess? > > Thanks, > > Viswa > -- > For information on using the ACCESS Developer Forums, or to unsubscribe, please see http://www.access-company.com/developers/forums/ > -- Best Regards, Dmitry Grinberg (847) 226 9295 -- For information on using the ACCESS Developer Forums, or to unsubscribe, please see http://www.access-company.com/developers/forums/ ----------------------------------------- "PLEASE NOTE: The preceding information may be confidential or privileged. It only should be used or disseminated for the purpose of conducting business with Parker. If you are not an intended recipient, please notify the sender by replying to this message and then delete the information from your system. Thank you for your cooperation." -- For information on using the ACCESS Developer Forums, or to unsubscribe, please see http://www.access-company.com/developers/forums/
