http://www.palmos.com/dev/tech/docs/devguide/ch10.htm#P210_13658
----- Original Message ----- From: "Sam Trimble" <[EMAIL PROTECTED]> Newsgroups: palm-dev-forum To: "Palm Developer Forum" <palm-dev-forum@news.palmos.com> Sent: Wednesday, June 21, 2000 5:46 PM Subject: Re: Debugging w/ Palm > It doesn't seem to be doing anything. And when I run the debugger it brings > up the "Failed to connect to remote" error everytime. Is there some special > place i have to enter this? > > "Nesse, Rustin" <[EMAIL PROTECTED]> wrote in message > news:[EMAIL PROTECTED] > > > > In Codewarrior, you just plop the Palm in the cradle, enable debugging, > > enter Shortcut dot dot 2 into your Palm, then hit Ctrl-F5 to start the > > debugger. Note...have a paper clip handy...you're going to be doing > > some resetting. You also have to be somewhat persistant sometimes, as > > the serial connection occasionally gets a little fuddled if you do > > something in the wrong order, so you may have to reset your Palm and > > try debugging again. > > > > -Rus > > > > -- > For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/ > > -- For information on using the ACCESS Developer Forums, or to unsubscribe, please see http://www.access-company.com/developers/forums/