Hi,
is not so dificult ...first of all I think that you are using Visual C++ if
that is the case , you need the CDK4 (download from www.palm.com) there is a
toolo to debug your conduit, you have to configurate that in your project.
When you download CDK4 there are pdf about how to make a simple conduits and
how to configurate the Conduit Inspector(that is the name) in order that you
can start debug and appear the icon of hotsync at the bottom of your screen.
Is important that when you run that you have to close the hotsync so the
debugger will start a new hotsync for debug.
After you have yur aplication in your palm emulator and have to configurate
your hotsync ,in your POSE, to sincronize betwen your POSE ad Visual C++.
Of course there is a way to configure that in your POSE and that information
is in ConduitReference.pdf as far as I remember. also need to install an
aplication in your POSE , netsync is the name , you can download fron
palm.com.
That is generic information , but dont worry in the pdf there is information
with more detail, but if something is strange , we are here :)
Good Luck
Emilio
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
