Well, the normal way to output a serial signal is to use a UART or some type of digital shift circuit. Typically, the UART would be mapped into the springboard memory space and accessed via UART chip registers with memory reads and writes. Trying to access the springboard connector like it is a peripheral is probably pointless. It is just a buffered extension of the CPU bus used inside the Visor. Good Luck, -jjf -----Original Message----- From: Page, Curt S [mailto:[EMAIL PROTECTED]] Sent: Thursday, January 11, 2001 8:13 AM To: Palm Developer Forum Subject: Reading in a serial signal via the springboard connector on a han dspring visor Now that I read my own message I guess I didn't make myself very clear. I have a springboard module that outputs a serial signal. Im trying to figure out a way to read that serial signal in via the springboard connector, which doesn't directly support serial inputs. Sorry for the confussion Curt -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/ -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/
