You can debug, using pose by assigning one of your PC's serial ports to
POSE, look in POSE setup (cant remember where).
This works quite well, although it does have a few problems.
Rik
> -----Original Message-----
> From: SH Luk [SMTP:[EMAIL PROTECTED]]
> Sent: 07 February 2001 11:22
> To: Palm Developer Forum
> Subject: Debug serial application
>
> I am developing an application which using the serial interface (HotSync)
> to
> connect my deivce . I would like to know how can I deubg my application as
> well as enable the serial communication. If I use POSE, as it is just
> software emulator, it don't have a physical serial port which allow me to
> feed it data. If I debug with the actual Visor with CodeWarrior, it is
> already sit on the cradle so that I can't plug in my device. So by what
> mean
> I can debug my application to see if it can response to the serial
> interface
> correct or not?
> Looking forward to your kindly advise.
>
> Tristan
>
>
>
> --
> For information on using the Palm Developer Forums, or to unsubscribe,
> please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
