Hi Mark,
I had the same problem. I ended up creating a bunch of invisible controls,
and then I move and show then as appropriate in response to the scroll
events. It was kind of a pain to set up, but it seems to work fairly well.
Craig
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Mark
Douglas
Sent: Wednesday, May 09, 2001 5:13 PM
To: Palm Developer Forum
Subject: Form Greater than 160 Pixels in height.
I have a lot of information that I need to place on a single form.
Unfortunately it won't all fit within the 160 vertical pixels.
Basically I need to create a scrolling form. Just like if you were to build
a PQA with many controls on it. When Clipper displays the PQA it places the
vertical scroll bar on the right side of the screen.
I tried creating a form and added a vertical scroll bar to it, but when I
add controls to the form I cannot exceed the 160 pixel limit.
Can this be done at all using CW7? Do I have to use a table to do this?
The types of controls are buttons, Entryfields, Labels, Check boxes etc...
I'm not sure if a table would work in these circumstances, since my controls
don't fit into rows and columns.
Can somebody point me in the right direction.
Mark Douglas
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/tech/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
