Do you get different results if you turn off either or both of the
logging options?
-- Keith
At 9:50 AM -0700 6/25/01, Steve Mann wrote:
>I'm trying to debug an older application (one that runs on 3.5 but
>not 4.0 totally successfully) using POSE 3.2 and CodeWarrior r7. I
>launch my application with the symbolic debugger, and it starts up
>fine. I then select Gremlins, select a single event turn on Event
>and System Calls logging, then hit the OK button.
>
>I immediately get the following error message:
>
>0.150 (0): === WARNING: XXXXX just read from memory location
>0x000033D2, which is in an unallocated chunk of memory.
>
>A stack trace shows the following:
>
>SysDoze
>68K
>68K
>HwrIRQHandler
>
>and the POSE log has the following:
>
>0.150 (0): --- System Call 0xA256: HwrIRQ6Handler.
>0.150 (0): === WARNING: Gremlin #1 Event 4294967295
>0.150 (0): === WARNING:
>********************************************************************************
>0.150 (0): === WARNING: XXXXX just read from memory location
>0x000033D2, which is in an unallocated chunk of memory.
>
>The error seems to occur on the first instruction of HwrIRQHandler.
>The disassembler points to
>
>10C8FB52: 207CFFFFF000 movea.l #-4096,a0
>
>and A0 has the value 0x0003E7D0.
>
>Has anyone seen this type of error. Any suggestions as to the nature
>of the problem or ways I might go about tracking it down? Thanks.
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/tech/support/forums/
