Hi all! I have a serious problem developing a stable solution using Palm HotSync 3.1.0 and an inhouse-developed conduit. The problem seems to only occur when I configure that conduit in a way that it shows a dialog during the sync operation. ( System: Win2k Dialog: Seperate DLL using MFC ) Sync works fine, but after HotSync has completed the Sync with all conduits, it seems to be in an invalid state, it crashes if you try to access its dialogs, and if you just push the sync button on the device again, there's this "Exit the current Hotsync Manager dialog to proceed with the synchronization" dialog ( which usually only occurs when you're still in some of HotSync's configuration dialogs but try to sync, but this time, there is no (visible) dialog ( that goes for the extra conduit dialog I already mentioned, too ) ), then it crashes. I know that the Palm guidelines say that you should not show an extra conduit dialog during sync ( btw: sad for nice progress dialogs ), but we _must_ show this dialog because the conduit communicates via network and needs a password entered by the user. What I would like to know is, do you have similar problems, is this normal, is there a way to avoid this strange HotSync behaviour ( and of course still keep showing that extra dialog ) ? I already figured out that it seems to be no problem to call for example the conduit conf dialog during sync. What is this? Can it have something to do with the use of MFC or an additional dll for the dialog? Please give me a hint if you can! Thanks, Patrick ---- patrick berzbach . weblicon technologies ag software developer sync technology torstrasse 6 . vox: +49 (0)30-72 62 69-127 . http://www.weblicon.net d-10119 berlin . fax: +49 (0)30-72 62 69-100 . [EMAIL PROTECTED] -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/
