I've found that sometimes I have to go to another app, then back to Launcher to get my app to show up, if it wasn't loaded when I started the session. Haven't checked with the latest rev of POSE yet. This also happens if I drop an app onto the POSE sessions, with Launcher active. All I do is run Address Book, then go back to Launcher. on 9/11/01 12:05, Jun-Kiat Lam at [EMAIL PROTECTED] wrote: > One thing comes to mind: is your application set to type 'appl' > (case-sensitive)? If it isn't, the Launcher will not display it. You can set > this in the PalmRez Post Linker panel settings (inside the Project Settings). > > -- jkl > > ----- Original Message ----- > From: "dele adedoyin" <[EMAIL PROTECTED]> > Newsgroups: palm-dev-forum > To: "Palm Developer Forum" <[EMAIL PROTECTED]> > Sent: Sunday, September 09, 2001 5:20 PM > Subject: Palm App does not save onto device after successfull 'run' and 'kill' > > >> Please help, >> >> I've been trying to figure this out for some time now. My app runs as >> expected after down loading, while debugging but after I kill the app, It is >> no longer on the device. I would expect the app to be saved on the device >> with the Icon(s) I created. >> >> Is there a setting in constructer or the CW IDE I have wrong? Any ideas at >> all on what I could possibly be missing would be infitely helpful. >> >> Gratefully, >> >> dele >> >> >> >> -- >> For information on using the Palm Developer Forums, or to unsubscribe, please > see http://www.palmos.com/dev/tech/support/forums/ > -Tom Hoelscher ~~~~~~~~~~~~~~~~~~~~~~~~~~ "Original Sin is hard to find, but the digitally enhanced version is readily available". -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/
