Read Heather' reply, and...
you can switch to the Segments tab. This should ONLY list the files that are in your current target. I always ignore the segments tab, until I get a link-order problem, then it's VERY useful. Doug. -----Original Message----- From: Ola Theander [mailto:[EMAIL PROTECTED]] Sent: Tuesday November 20, 2001 08:45 To: Palm Developer Forum Subject: HowTo: Determine which files is included in a target (CW 8)? Dear subscribers. In my project I've built a tree containing the project's header and source files. The project have two targets, debug and release, where each target have a few files only included in that target. The problem is that there is no way, that I've discovered, that allow me to see which files that are included in the each target. The most intuitive way would be to have independent source trees for each target or perhaps to highlight the active files in some way. Any help on this matter would be greatly appreciated. Kind regards, Ola Theander -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/tech/support/forums/
