First off, you should be using the CDK InstallAid routines to install your conduit. Secondly, you should post conduit questions to the conduit forum
>Any idea where I can check? Have your checked to make sure any and all files your conduit depends on are available for it to open? More often than not, a conduit will not appear in the custom dialog because they failed to load. A utility like Dependency Walker could help (a MS utility) > The creator id should not matter at this point in time...? Only if the particular creator ID is not already registered to another conduit. ----- Original Message ----- From: "Louis" <[EMAIL PROTECTED]> To: "Palm Developer Forum" <[EMAIL PROTECTED]> Sent: Wednesday, August 28, 2002 10:33 AM Subject: Problem registering my conduit > I seem to have a problem with registering my conduit: > > Close HSync manager > I create the necessary registry keys under the > HKEY_CurrentUser>software>usrobotics>Application3 > Run HSync manager > > If I go to custom setup, i do not see my conduit there, but if i run > CondCfg it shows it there. > > I have gone through these steps many times with previus conduits, byt this > one refuses. Any idea where I can check? > > The creator id should not matter at this point in time...? > > Thanks > > > > > -- > For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/ > -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
