I've run into a problem many times with POSE and I'm wondering if there is something that can be done about it....
Here's the problem: I'm debugging on POSE using CW. The device goes to sleep. Now I (stupidly, because I've done this a 100 times), attempt to set a break point while POSE is asleep. Of course this doesn't work and now POSE is hung and the debugging session that I've very carefully setup and let run over night to get it to just the right place is hosed. Is there anything that can be done about this? Is there a particular place in the POSE code were I can look to change this behavior? This has been around for years and has cost me countless hours (yes, as I admit, I'm stupid for continually making the same mistake). Thanks, Kevin ------------------------------------------ The information in this transmittal and any attachments is privileged and confidential and is intended only for the recipient(s) listed above. You are hereby notified that any unauthorized distribution or copying of this transmittal or its attachments is prohibited. If you have received this transmittal in error, please notify Invivodata immediately at (831) 438-9550. ------------------------------------------ -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
