Ben, thank you very much for your tip, I'm trying it but it's not working. I only get a blank screen with a green line at the bottom, but no small blinking square, the NEXT button appears (the port is open), but I get the error "Bad response packet received from the handheld" when I click the next button.
I'm using the flash utility that came with the OS3.3 upgrade, and a serial cradle. Merry Christmas to all, thanks Pablo -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Ben Combee Sent: Tuesday, 24 de December de 2002 12:26 am To: Palm Developer Forum Subject: Re: How do I enter to debug mode in a m515?? At 19:55 2002-12-23 -0500, you wrote: >Hi all, > >I'm trying to enter into debug mode with my m515, doing >the pin reset while pressing the down scroll button >but, it never shows the blinking square. > >When I do the shortcut dot 1(debug mode), the serial >connection is made, but the blinking square never >appears, and I cannot reflash the m515 exiting with an >error (bad response). > >I was doing this process with my Palm V and it was >working good, but not with my m515. On the Palm m500, m505, m515 devices, you must hold both the up and down buttons on reset to get the device in debug mode to allow flashing of the ROM image. -- Ben Combee <[EMAIL PROTECTED]> CodeWarrior for Palm OS technical lead Palm OS programming help @ www.palmoswerks.com -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/ -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
