Hi, Page 12 in your owner' s manual shows that, small L dot dot 2, and you are in console mode. The app should load.
"Vijayasaradhi D."
<[EMAIL PROTECTED] To: "Palm Developer Forum"
<[EMAIL PROTECTED]>
> cc: <[EMAIL
PROTECTED]>
Sent by: Subject: Problems in
debugging Armlet using code warrior 9.2 on Treo 600 device
[EMAIL PROTECTED]
.palmos.com
10/28/2003 10:03 AM
Please respond to "Palm
Developer Forum"
Hi All,
I am trying to debug an armlet application using code warrior 9.2, on a
treo 600 device.
The device is connected to the PC using USB connection, and I have made the
following changes in
Target settings panel, Palm OS debugging as connect to device using USB.
I did the following steps
1)Run the Debug pref application and enbled ARM debugging enable now.
1)Run the DotDotTwo CodeWarrior sample application on Treo600 device to get
it in console mode.
The IDE says please place the device in console mode using short cut 2.
Please help.
Regards,
Saradhi
--
For information on using the Palm Developer Forums, or to unsubscribe,
please see http://www.palmos.com/dev/support/forums/
--
For information on using the Palm Developer Forums, or to unsubscribe, please see
http://www.palmos.com/dev/support/forums/
