Hi, thanks for the reply, Yes I am removing the data from the buffer after i read it. If I want to use software flow control even the device has to support it , right??
Marianne ----- Original Message ----- From: "Dave Lippincott" <[EMAIL PROTECTED]> To: "Palm Developer Forum" <[EMAIL PROTECTED]> Sent: Tuesday, December 02, 2003 7:45 PM Subject: Re: Error : serLineErrorSWOverrun > Try increasing the buffer size. Over-run errors typically mean more data > was received into the serial buffer than you took out. Are you removing the > data from the buffer after you read it or just leaving it there? > Can you use a flow control protocol? Either software or hardware flow > control would also help eliminate this issue. > > ----- Original Message ----- > From: "Marianne" <[EMAIL PROTECTED]> > To: "Palm Developer Forum" <[EMAIL PROTECTED]> > Sent: Tuesday, December 02, 2003 4:17 AM > Subject: Error : serLineErrorSWOverrun > > > > > > Hello All, > > > > We have written an application that reads from the serial port at the rate > > of 1 tick. But when it receives too much data it gives > > "serLineErrorSWOverrun" Line Error. Why is this so, does anyone have any > > idea. > > > > Thanks in advance > > > > Marianne > > > > > > -- > > For information on using the Palm Developer Forums, or to unsubscribe, > please see http://www.palmos.com/dev/support/forums/ > > > > > -- > For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/ > -- For information on using the Palm Developer Forums, or to unsubscribe, please see http://www.palmos.com/dev/support/forums/
