Well, your fingers are better at working on the small models than mine, Ha! No, the base didn't require and weight(s) and I was surprised too, but there is just enough offset in the angle of the tree that the bear is sitting on to make it stable. Good luck if you build it and be sure and post that LITTLE fella/gal.... Bob D...
--- On Mon, 10/5/09, [email protected] <[email protected]> wrote: From: [email protected] <[email protected]> Subject: [Papermodels II 40289] Re: Canon Koala Bear To: [email protected] Date: Monday, October 5, 2009, 12:44 PM In a message dated 10/5/09 11:16:09 AM, [email protected] writes: Just finished the Canon Koala Bear model. It is about 11 inches tall when completed at 100% size. Not a hard build but it takes patience especially on the ears and when attaching the legs. Hi Bob, Nice! Thank you for posting. That Koala model is tempting to print out half size..or smaller. Was it necessary to add weight in the base? Bob Penikas --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "Papermodels II" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/papermodels?hl=en -~----------~----~----~----~------~----~------~--~---
