If it is the exodus reader, the apply displacements enabled means the reader
will look for a vector variable dislp_{x,y,z} or variants of that, and add the
vector to the nodal coordinates at each time step. The mag is a factor that
rescales the displacement vector, set to 1 by default. X(t) = X(0) +
mag*displ(t).
Greg
On 8/26/08 10:41 PM, "Gang" <[EMAIL PROTECTED]> wrote:
Hi everyone,
I have a question about the Interface of the Paraview3.3.0（development）.
In the Properties tab, there is a Apply Displacements checkbox, following
it, there is a mag .
Know little about it , and search it on the net, helpless....
can someone give any explanation?
thanks
Gang
2008-08-27
________________________________
Gang
_______________________________________________
ParaView mailing list
[email protected]
http://www.paraview.org/mailman/listinfo/paraview
